第三种是ISIS.这是最奇怪的一种.有玩过的就知道,ISIS的routing command是下在interface mode而不在routing mode.所以如果把一个网段加入,就用ip router isis命令.好了,问题是,如果我不要这个interface收送isis routing update,但是又要这个interface所属的网段要加入ISIS的routing之中,那要怎么做??答案就是用pass...
A.So that routers do not become OSPF neighbors on a particular interface, issue the passive-interface command at the interface. In Internet service provider (ISP) and large enterprise networks, many of the distribution routers have more than 200 interfaces. To configurepassive-interfaceon each of ...
The no form of the command reverts the status to active OSPF interface. Syntax Description N/A Default Active interface (no ip ospf passive-interface) Configuration Mode config interface vlan config interface ethernet (configured as a router port interface) config interface port-channel (configu...
Undo Network Command:network命令被删除 Undo NBMA Peer:NBMA类型接口上的邻居配置被删除 Passive Interface Down:由于本端配置了silent-interface命令,导致邻居关系Down Opaque Capability Enabled:使能了opauqe能力 Opaque Capability Disabled:去使能opauqe能力 Virtual Interface State Change:虚连接接口状态变化 BFD Sess...
Undo Network Command:network命令被删除 Undo NBMA Peer:NBMA类型接口上的邻居配置被删除 Passive Interface Down:由于本端配置了silent-interface命令,导致邻居关系Down Opaque Capability Enabled:使能了opaque能力 Opaque Capability Disabled:去使能opaque能力
The no form of the command enables routing updates on an interface. passive-interface {vlan 1-4094 | interface-type interface-id} no passive-interface {vlan 1-4094 | interface-type interface-id} Syntax Description vlan-id - LSA retransmissions for adjacencies belonging to the VLAN interface....
8.15.12 OSPF network Command network ip-address wild-card-mask area area-id 用于通告和定义OSPF的区域,其中要使用wild-card-mask Area-id 可以使用 点分10进制的形式 8.15.13 Passive OSPF Interfaces passive-interface interface-name interface-number ...
A disabled interface is a passive interface, which cannot send any hello packet. To make no routing information obtained by other routers on a network segment, you can use this command to disable the interface from sending OSPF packets. Examples # Disable an interface from sending OSPF packets....
When we add a subnet by network command and add passive-interface to it,It stops all the OSPF processes for that interface ,but OSPF is UP. Is it used to advertise subnet on the passive-interface to the network? What is the real need of that interface? If that interface goes down ,...
10、PASSIVE接口(OSPF中的passive接口不收发hello报文) R2#show ip os neighbor \\查看邻居状态 Neighbor ID Pri State Dead Time Address Interface 12.1.1.1 1 FULL/DR 00:00:38 12.1.1.1 FastEthernet0/0 (邻居状态机/接口状态机) <wiz_tmp_tag id="wiz-table-range-border" contenteditable="false" styl...