I'm trying to configure OSPF routing on a network that includes Layer 3 switches and routers. I've got the routers communicating, however the switches are not.The switch ports have been given IP addresses, and I've set up OSPF routing on them, advertising the attached networks. However, n...
Perform the following steps on theswitchrunning OSPF. Procedure Run: system-view The system view is displayed. Run: interfaceinterface-typeinterface-number The interface view is displayed. On an Ethernet interface, run: undo portswitch The interface is switched to Layer 3 mode. ...
(Optional) On an Ethernet interface, run undo portswitch The interface is switched to Layer 3 mode. By default, an Ethernet interface works in Layer 2 mode. Only the S5731-H, S5731-S, S5731S-H, S5731S-S, S5732-H, S6735-S, S6720-EI, S6720S-EI, S6730-H, S6730S-H, ...
The information in this document is based on the software and hardware versions listed: OSPF can be configured in all routers, such as the Cisco 2900 series, and Layer 3 switches. OSPF is supported in Cisco IOS®Software Releases 10.0 and later. ...
· 如果stub-router max-metric命令中指定了on-startup参数,在Stub路由器功能未生效期间,仅Isolate功能会影响流量转发路径。 3. 配置步骤 (1) 进入系统视图。 system-view (2) 进入OSPFv3视图。 ospfv3 [ process-id | vpn-instance vpn-instance-name ] * (3) 使用OSPFv3 isolate功能对设备的OSPFv3协议进行...
(3) 配置当前路由器为Stub路由器。请选择其中一项进行配置。 ¡ 配置当前路由器为Stub路由器,且发布的Type-1 LSA中的options域的R-bit将被清除。 stub-router r-bit [ include-stub | on-startup { seconds | wait-for-bgp [ seconds ] } ] * ¡ 配置当前路由器为Stub路由器,且发布的Type-1 LSA...
Step 3 (Optional) router-id ip-address Example: switch(config-router)# router-id 192.0.2.1 (Optional) Configures the OSPFv3 router ID. This ID uses the dotted decimal notation and identifies this OSPFv3 instance and must exist on a configur...
All interfaces on the switch with an IP address that matches subnet 2001:db8::a0a:0a65/128 and swp1 with IP address 2001:db8::a00:0100/127 are in area 0.0.0.0. NCLU Commands When you commit a change that configures a new routing service such as OSPF, the FRR daemon re...
Layer 1 and Switch Ports Layer 2 Network Virtualization Layer 3 Routing Border Gateway Protocol - BGP Open Shortest Path First - OSPF Open Shortest Path First v2 - OSPFv2 Open Shortest Path First v3 - OSPFv3 OSPF Configuration Example VRFs FRRouting Protocol Independent Multicast - PI...
This chapter describes how to configure Open Shortest Path First version 3(OSPFv3) for IPv6 networks on the Cisco NX-OS device. This chapter includes the following sections: Information About OSPFv3 OSPFv3 is an IETF link-state protocol (see “Overview” section). An OSPF...