An obvious solution to the orange light problem is to turn the modem on and off again. Start by unplugging the device from the wall socket. Leave it unplugged for about 1 minute. If your modem is run on a battery, simply take the battery out and then put it back in after 1 minute....
Both ethernet leds light up but there is no red led anywhere to be seen. Reply Author cnxsoft 9 years ago @Rien Kriboo I’ve explained what I did for Orange Pi mini 2 (same as Orange Pi PC minus one USB port) with Debian 8 @ http://www.cnx-software.com/2015/09/01/ge...
Let me rephrase: this is headless - I'll need to hunt around for cables to connect it to a screen... The green LED is solid, the red > LED blinks twice then pauses, repeat. And it never powers up the ethernet port. Hmm, looks like a kernel crash: In bootloader stage, the red ...
Power light is on, no activity blinking LED. Network link and activity blinking. Just won't boot. Requires physically disconnecting power for a few seconds then re-plug to get to boot. I have watchdog set in Armbian and tested that works. So this seems to be before Linux kernel has ...
CONFIG_SH_ETHER Support for Renesas on-chip Ethernet controller CONFIG_SH_ETHER_USE_PORT Define the number of ports to be used CONFIG_SH_ETHER_PHY_ADDR Define the ETH PHY's address CONFIG_SH_ETHER_CACHE_WRITEBACK If this option is set, the driver enables cache flush. TPM Support: ...
CONFIG_SH_ETHER Support for Renesas on-chip Ethernet controller CONFIG_SH_ETHER_USE_PORT Define the number of ports to be used CONFIG_SH_ETHER_PHY_ADDR Define the ETH PHY's address CONFIG_SH_ETHER_CACHE_WRITEBACK If this option is set, the driver enables cache flush. - PWM Support: ...
Support for Renesas on-chip Ethernet controller CONFIG_SH_ETHER_USE_PORT Define the number of ports to be used CONFIG_SH_ETHER_PHY_ADDR Define the ETH PHY's address CONFIG_SH_ETHER_CACHE_WRITEBACK If this option is set, the driver enables cache flush. -...
Support for Renesas on-chip Ethernet controller CONFIG_SH_ETHER_USE_PORT Define the number of ports to be used CONFIG_SH_ETHER_PHY_ADDR Define the ETH PHY's address CONFIG_SH_ETHER_CACHE_WRITEBACK If this option is set, the driver enables cache flush. - PWM Support: ...