The LED turns ON if USB device is connected. If not installed already, install it with: root@lede:/# opkg install kmod-ledtrig-usbdev To find out device name use logread to search for it or list /sys/bus/usb/devices (for this example, there would be /sys/bus/usb/devices/1-1 dev...
使用iw list命令， 然后找到对应的modes：Supported interface modes:* IBSS * managed * AP * AP/...
(10)USB Device The LED turns ON if USB device is connected. To find out device name use logread to search for it or list /sys/bus/usb/devices (for this example, there would be /sys/bus/usb/devices/1-1 device). (11)Morse Code The LED signals a message using Morse code. (12)GP...
This is a known problem, and it is not caused by the bridge code. Many wireless cards don't allow spoofing of the source address. It is a firmware restriction with some chipsets. You might find some information in the bridge mailing list archives to help. Has anyone found a way to get...
Hi, I set up a Router with Zerotier because I want to reach devices connected to its LAN ports. So far I can reach the router via Zerotier network, but no devices that are connected to that router - although they are i…
iw list 扫描 iw dev wlan0 scan 监听事件 只要使用 iw event 调试时观察auth/assoc/deauth/disassoc帧可能有帮助,使用 iw event -f 有时时间信息也是有用的: iw event -t 获得链路状态 为了确定您是否连接到一个AP上,如果你是最后一个使用的发送速率,您可以使用下面的命令。
Associated Station list has not been cancelled after it has been disconnected. The status seems like frozen. If I check on realtime graph for Wireless, there is no data showing (obviously no further devices connected). It is an android device with ...
{"hass":{"description":"Home Assistant OpenWrt integration permissions","read":{"ubus":{"network.wireless":["status"],"network.device":["status"],"iwinfo":["info","assoclist"],"hostapd.*":["get_clients","wps_status"],"system":["board"],"mwan3":["status"]},},"write":{"ubus...
Parser for iw and iwinfo on OpenWrt devices. Currently supports only device list and connected stations data. Output from iw and iwinfo on other platforms might work, but it's not tested. Table of contents Installation python -m pip install -U ap-parse ...
Two computers connected to the same network. Installation Connect the USB device to the router’s USB port. Log in to OpenWrt’s web interface and navigate to “System” -> “Software”. Click on “Update lists” to refresh the package list. ...