vllogic/openocd_cmsis-dap_v2Public NotificationsYou must be signed in to change notification settings Fork18 Star47 Code Issues master 5Branches8Tags Code # Welcome to OpenOCD! OpenOCD provides on-chip programm
interface cmsis-dap transport select swd source [find target/stm32f1x.cfg] 然后连接CMSIS-DAP和stm32f103,加载脚本 openocd -f ./ocd-stm32.cfg 这样显示就是连接成功了,可以看到时钟速度是1000 Khz Open On-Chip Debugger 0.9.0 (2015-05-19-12:09) Licensed under GNU GPL v2 For bug reports, read...
CMSIS-DAP v2 (USB bulk based) adapter driver Nuvoton Nu-Link and Nu-Link2 adapter drivers NXP IMX GPIO mmap based adapter driver ST-Link consolidate all versions in single config ST-Link read properly old USB serial numbers STLink/V3 support (for ST devices only) 二、安装openOCD 1. 下载...
支持CMSIS-DAP v2接口协议,支持ARM、RISCV、ESP32等目标芯片,详见Wiki及release - enable the Bus Pirate adapter by default on most systems · vllogic/openocd_cmsis-dap_v2@9ff79fd
auto First try USB bulk CMSIS-DAP v2, if not found try HID CMSIS-DAP v1. This is the default if cmsis_dap_backend is not specified. Config Command: cmsis_dap_usb interface [number] Specifies the number of the USB interface to use in v2 mode (USB bulk). In most cases need not to...
用cmsis-dap时进行openocd时报错,如下。 是不是官方安装软件内安装的openocd不支持cmsisi-dap?需要重新编译一下openocd? Open On-Chip Debugger v0.10.0-esp32-20210401 (2021-04-01-15:46) Licensed under GNU GPL v2 For bug reports, read http://openocd.org/doc/doxygen/bugs.html ...
CMSIS-DAP v2 (USB bulk based) adapter driver Nuvoton Nu-Link and Nu-Link2 adapter drivers NXP IMX GPIO mmap based adapter driver ST-Link consolidate all versions in single config ST-Link read properly old USB serial numbers STLink/V3 support (for ST devices only) ...
[[cmsis_dap_v2], [CMSIS-DAP v2 Compliant Debugger], [CMSIS_DAP_USB]], [[osbdm], [OSBDM (JTAG only) Programmer], [OSBDM]], [[opendous], [eStick/opendous JTAG Programmer], [OPENDOUS]], [[aice], [Andes JTAG Programmer], [AICE]]]) @@ -129,7 +130,7 @@ m4_define([USB0...
[cmsis_dap_v2], [CMSIS-DAP v2 Compliant Debugger], [CMSIS_DAP_USB]], [[osbdm], [OSBDM (JTAG only) Programmer], [OSBDM]], [[opendous], [eStick/opendous JTAG Programmer], [OPENDOUS]], [[armjtagew], [Olimex ARM-JTAG-EW Programmer], [ARMJTAGEW]], [[rlink], [Raisonance RLink...
目标芯片配置文件是openOCD支持的目标芯片，在 scripts\\target 文件夹下；比如这里我使用ST-Link v2-1...