而我們自己家用則是用途很廣泛,今天阿湯要來介紹的這款給奇創造筆記型螢幕 ON-LAP 1002 為 10.1 吋,具有 10 指多點觸控、IPS 面板,當然看完這樣的規格就知道很適合用在 Windows 8 系統,阿湯也應用這樣的螢幕在自己的電腦打造了雙系統,桌機跑 Windows 7,而在這觸控螢幕上則變身成為...
surface roughnesstensile and compressive loadingThe lap shear strength of epoxy adhesive is determined experimentally using adhesive-bonded single lap joints with two similar adherends, aluminium alloy and steel, following ASTM standards D1002 and D905 in tensile and compressive loading. Thicknesses of ...
Designation D 1002-94, Annual Book of ASTM Standards. “Standard test method for impact strength of adhesive bonds”. Designation D 950-94, Annual Book of ASTM Standards. Kinloch, A. J. and Kodokian, G. A., 1987, “The impact resistance of structural adhesive joints.” Journal of ...
Tensile tests to the single lap joint (SLJ) were performed according to standard ASTM D 1002-01, at room temperature. The static tensile test revealed an incremental degradation of the mechanical strength in the adhesive joint compared to SLJ without aging. For the maximum displacement of the ...
Simple design rules exist such as the one present in standard ASTM 1002 or in a recent paper by Adams and Davies. The main factors that have an influence on the lap shear strength are the type of adhesive, i. e. ductile or brittle, the adherend yield strength and the overlap length. ...
This paper extensively discusses and compares the individual and combined influence of four different environmental factors, static and dynamic loading, UV radiation, temperature and humidity, on the residual strength of a single lap shear joint (ASTM D 1002-05). A design of experiment approach is...
The artificially defective samples are examined under the axial tensile tests according to ASTM D1002-01 standard. In the case of the single lap joints with 3D defects, there is an approximately linear decrease in the joint strength as the defect area increases. However, when 2D defects are ...
The aluminum adherends were mixed adhesive joined with the standard of ASTMD 1002 in single lap joint (SLJ) type. The composition variation of mixed adhesive was 100%EP, 75%EP:25%SMP, 50%EP:50%SMP, 25%EP:75%SMP and 100%SMP. The adhesive thickness was varied of 0.2 mm, 0.4 mm ...