5 ERROR indicator (red) When a processing error is detected (when SSACK is other than NO), this indicator is lit for 50 ms. 6 24 VDC power supply termi- Connect to the 24 VDC power supply. nals (with cover) 7 Frame ground terminal The grounding wire is connected here. (Ground to ...
开机运行报程序错误ERROR NO.10故障实拍修复位置真相标注如下：修复后，立即能进入系统ok如下：...
12、to 000000FE 1 到 254 错误信息码表: Error code (hexadecimal) Details 00000000 Normal 00000001 The header is not FINS (ASGII code). 00000002 The data length is too long. 00000003 The comma nd is not &upoor:ed. 00000020 All connections are in use. 00000021 The specified node is alread...
显示 意义 原因 控制输出 When an error occurs, the display shows the error code. Take necessary measures, referring the following table. Display Bedeutung Ursache Regelausgang 反向运行 :OFF Display Meaning Cause Control output FFF (点亮) 上溢出 过程值大于设定的温度范围。 FFF (leuchtet) Überlauf...
Up to 20 errors are stored in the error log. Information includes the error code, error details, and the time the error occurred. Error log A CJ1M CPU Unit can be set so that user-defined FAL errors are not stored in the error log. Built-in peripheral port: Programming Device (...
Errorflag(Error)”将打开,如果 FB 发生 错误,将输出 Errorcode(ErrorID)”。其他 FB 或 FB 的其他实例中的错误不会发生这种情况。当 Start(Execute)”关闭时,这些状态 ( mandAborted/Error/ErrorID)将被重置.如果在定位操作完成之前 启动(执行)”变为 OFF,则当相应条件发生时,状态将被设置至少一个周期 ON ...
When an error has occurred, the No.1 display shows the error code. Take necessary measure according to the error code, referring the table below.If the input value exceeds the display limit ( - 19999 to 32400), though it is within the control range, [[[ will be displayed under −1999...
CX-Position,Ver.2. 5. 2. 0 Face Plate Auto-Builder for NS,Ver.3. 1. 1. 1 CX-Thermo,...
Fatal error in the Unit.• Check the CPU unit for error codes. • Re-start the PLC system.• If the ERC LED is still lit, replace the unit.OFF • Measurement of the corresponding channel is within range, or • Channel has been deactivated by DIP switch settings ON • Measured...
Handshake[15] = 0;//Error Code Handshake[16] = 0; Handshake[17] = 0; Handshake[18] = 0; Handshake[19] = Client[3];//FINS Frame (本机节点) msock.Send(Handshake); byte[] buffer = new byte[24]; msock.Receive(buffer, SocketFlags.None); ...