Several different types of calorimetric cell designs were used to attempts to measure excess enthalpy during the electrolysis of LiOD + D20 using palladium cathodes. Control experiments were run by using light water in place of D2O or by using platinum cathodes in place of palladium. Previous ...
Electrolysis of water on oxide surfaces J. Electroanal. Chem., 607 (2007), pp. 83-89, 10.1016/j.jelechem.2006.11.008 View PDFView articleView in ScopusGoogle Scholar Seh et al., 2017 Z.W. Seh, J. Kibsgaard, C.F. Dickens, I. Chorkendorff, J.K. Nørskov, T.F. Jaramillo Combini...
Polymer electrolyte membrane water electrolysis (PEMEC) is viewed as a clean and promising way to convert electrical energy to hydrogen, playing an important role in modern sustainable energy conversion and storage devices1,2,3. Due to the sluggish oxygen evolution reaction (OER) kinetics and harsh...
implying fast HER kinetics (Fig.2b). The low Tafel slope in alkaline electrolytes suggests that the rate-determining step should be the H desorption process, rather than the water dissociation (Volmer step)50,52. Turnover frequency (TOF) per real active site of the SRO catalyst is obtained...
Heavy elements are observed that might have been produced by such reactions during electrolysis of heavy water. Elements such as sodium, magnesium, aluminum, and zinc are observed inside grain-shaped defects in a palladium rod used in a cold fusion experiment....
To confirm the emission of the "iton" particles predicted by the Nattoh model, a cold fusion experiment based on electrolysis of heavy water has been performed. The tracks of several kinds of itons have been successfully recorded on nuclear films. The formation and decay mechanisms of itons ...
Cold fusion products from the electrolysis of heavy water have been directly measured by using a thin palladium foil. Several anomalous traces have been clearly recorded on nuclear emulsions. Some traces have meshlike structures, which are classified into two types: (a) ones associated with ring ...
water electrolysisnanoconfinementfluorescenceelectric double layerBipolar electrodes (BPEs) are conductors that, when exposed to an electric field, polarize and promote the accumulation of counterionic charge near their poles. The rich physics of electrokinetic behavior near BPEs has not yet been ...
(-) electrode to another electrode and dipping in the water bath; applying voltage of 8V and current of 250mA in the power supply to execute electrolysis for 10-15 seconds and to maximize the etching selection ratio of aluminum layer(50), Ti layer(42) and TiN layer(44) in the part ...
The demonstrated parallel trends in in situ ETEM and electrolysis studies underpins that the observation of enhanced surface dynamics of Mn adatoms in H2O is highly relevant for the real-world electrochemical behavior of the manganite electrodes. Clearly, there are differences in the properties of a...