9.4.3 最小切削长度（MinimumCutLength） 181 9.4.4 切削方向（CutDirection） 181 9.4.5 切削顺序（CutOrder） 181 9.4.6 删除边缘跟踪（RemoveEdgeTraces） 182 9.4.7 在边上延伸（ExtendatEdges） 182 9.4.8 使用2D工件（Save2DIPW） 183 9.4.9 层到层（LeveltoLevel） 183 9.4.10 ...
NX8数控铣编程简明教程第8章 第8章 孔加工 第8章孔加工 8.1孔加工特点8.2孔加工工序子类型 8.3创建孔加工工序步骤 8.4钻削几何及其定义8.5孔加工工序参数设置8.6孔加工循环方式8.7循环参数设置 第8章 孔加工 8.1孔 加 工 特 点 1．孔加工孔加工泛指孔的各种加工，如钻孔(通孔、盲孔、...
I'd try making sure there is a minimum linear move at the cutcom event (i.e. the NX5 equivalent of NX4's "Machine" -> Cutter comp -> minimum move) and see what happens. Ken Ken Akerboom kakerboom@moog.com akerboom@sea4ug.com Moog, Inc. Specialty Engineered Automation www.moog...
• Minimum strength length – a violation is created when the length of stock is too short between two bends. • Connection compatibility – a violation is created when an invalid connection is made between two parts, or between stock and a part. • Flow direction – NX checks ...
用户可在绘图工作区中,选择已建立局部剖视边界的视图作为父视图。并可在对话框中选取Cut Through Model选项,它用于将局部剖视边界以内的图形部分清除。l 指定基点基点是用于指定剖切位置的点。选择视图后,指定基点图标被激活,对话框的视图列表框会变为点创建功能选项。在与局部剖视图相关的投影视图中,用点功能选项...
The board can be powered on again only after the temperature falls below the (threshold - hysteresis) degree Celsius. If the board cannot be sufficiently cooled, to completely cut off the power to TMP451 and reset the TEMP_THERM signal, unplug ...
TIP create a shortcut such as: alias pnx="pnpm nx --" > NX Report complete - copy this into the issue template Node : 20.1.0 OS : darwin-arm64 pnpm : 8.5.1 nx : 16.5.0 @nx/js : 16.5.0 @nx/jest : 16.5.0 @nx/linter : 16.5.0 @nx/workspace : 16.5.0 @nx/cypress : ...
Workaround: Increase the frequency of PTP announce/sync messages and reduce the timeout values to configurable minimum. This should shorten the duration for which Nexus 9000 uses its local clock for reference. CSCwb08528 Headline: MAC learned on orphan port does not ...
—Minimum Buffers (default – 0) ■The Cisco Nexus 9508 ACI-mode switch supports warm (stateless) standby where the state is not synched between the active and the standby supervisor modules. For an online insertion and removal (OIR) or reload of the active supervisor module, the...