(Optional) Configuring the NTP Client/Server Mode Context When the client/server mode is used, you need to perform the following configurations on the client: Procedure Enter the system view. system-view (Optional) Configure the maximum polling interval in unsynchronized mode and the step value...
Figure 7-12 Configuring the NTP client/server mode with authentication In this example, Interface1 and Interface2 represent Vlanif10 and Vlanif20, respectively. Precautions Before specifying the NTP server address and the authentication key to be sent to the NTP server, y...
如果您继续使用我们的网站,即表示您确认允许使用 Cookie。隐私声明 更改设置
When configuring NTP authentication in the unicast server/client mode, enable the NTP authentication on the client, and then specify the NTP server address and the authentication cipher to be sent to the server. If these operatio...
When configuring NTP authentication in the unicast server/client mode, enable the NTP authentication on the client, and then specify the NTP server address and the authentication cipher to be sent to the server. If these operations are not performed, the NTP server and client directly synchronize...
The NTP unicast server/client mode is used to synchronize the clocks of RouterB, RouterC, and RouterD. RouterB functions as the server, while RouterC and RouterD function as the clients. RouterA and RouterB are connected through the network, which is not secure, so that the NTP authentic...
This document describes the configurations of Device Management, including device status query, hardware management, CSS, SVF, PoE, OPS, OIDS, energy-saving management, information center, fault management, NTP, synchronous ethernet, PTP.
The NTP unicast server/client mode is used to synchronize the clocks of RouterA and RouterB. RouterA functions as the server, and RouterB functions as the client. The NTP unicast server/client mode is used to synchronize the clocks of RouterB, RouterC, and RouterD. RouterB functions as ...
Configure the NTP unicast server/client mode to synchronize the clocks of SwitchA, SwitchB, and SwitchC. Configure SwitchA as the NTP server and SwitchB and SwitchC as NTP clients. Enable NTP authentication to ensure NTP clock synchronization security....
The NTP unicast server/client mode is used to synchronize the clocks of RouterB, RouterC, and RouterD. RouterB functions as the server, while RouterC and RouterD function as the clients. RouterA and RouterB are connected through the network, which is not secure, so that the NTP authentic...