ntp-service server server-source命令用来配置NTP服务的源接口。 undo ntp-service source-interface命令用来恢复NTP服务的源接口为缺省情况。 缺省情况下,未指定NTP服务的源接口。出厂配置文件中,有管理网口的设备指定源接口为管理网口;无管理网口的设备指定源接口为VLANIF 1。 命令格式 ntp
ntp-service server disable 命令功能 ntp-service server disable命令用来去使能NTP服务器功能。 undo ntp-service server disable命令用来使能NTP服务器功能。 缺省情况下,NTP服务器使能。 命令格式 ntp-serviceserverdisable undo ntp-serviceserverdisable 参数说明 无 视图 系统视图 缺省级别 2: 配置级 使用指南 为了...
ntp-service broadcast-server 命令功能 ntp-service broadcast-server命令用来配置NTP广播服务器模式。 undo ntp-service broadcast-server命令用来取消NTP广播服务器模式。 缺省情况下,未配置广播服务器模式。 命令格式 ntp-service broadcast-server[versionnumber|authentication-keyidkey-id]*...
The appliance supports one NTP server at a time. To designate a new NTP server, use the no ntp-service command to delete the current server, and then use the remote-server command to designate the new server.
由于要做一个集群,发现PXE安装的几个时间都不相同,于是就临时在PXE上面做了个NTP server供几台节点使用。现在分享一下安装方法。 NTP通信协议原理: 1、首先主机启动NTP 2、客户端会向NTP服务器发送调整时间的message 3、然后NTP server会送出当前标准的时间给client ...
server 127.127.1.0# 如果公网NTP不可用时,将使用Local时间作为NTP服务提供给NTP Client。# Use Ubuntu's ntp server as a fallback.server # Access control configuration; see/usr/share/doc/ntp-doc/html/accopt.htmlfor# details. The web page<http://support.ntp.org/bin/view/Support/AccessRestrictions...
com in dns mgmt points to old, nonexistent server plus NO OTHER FOLDERS : The security descriptor propagation task could not calculate a new security descriptor for the following object. .bat file to Run after the user's logon 'ms-DS-MachineAccountQuota' Recommendation 'object * contains ...
com in dns mgmt points to old, nonexistent server plus NO OTHER FOLDERS : The security descriptor propagation task could not calculate a new security descriptor for the following object. .bat file to Run after the user's logon 'ms-DS-MachineAccountQuota' Recommendation 'object * contains ...
Change NTP service to public or internal NTP server (IP address or FQDN) Change status of ntpd in chkconfig list check the status of ntpd by running the command: chkconfig --list ntpd It will be in off state, turn it on by running the command: ...
refid: the NTP server one stratum above to which the NTP server on this stratum is synchronized. st: the stratum of the remote server. The stratum of a server can be set to 1 through 16 from high to low. In order to relieve the load and network congestion, you should avoid connecting...