地址不能包含0x00前缀和格式为0x00XXXXXX(长度4)/ 0x0000XXXX(长度5)的地址。 这样的零地址将导致返回错误代码NRF_ERROR_INVALID_PARAM。 注意:ESB中的字节排序和nRF5无线电外设不一样,因为地址字节在ESB中重新排列以匹配nRF24L无线电 PTX FIFO处理 在PTX模式下启用ESB时,上传到TX FIFO
return NRF_ERROR_INVALID_PARAM; } uint8_t temp_len; uint32_t err_code; g_send_msg.start = 0; g_send_msg.max_len = len; g_send_msg.pdata = pdata; temp_len = len>20?20:len; err_code = ble_nus_string_send(&m_nus, pdata, temp_len); if ( NRF_SUCCESS == err_code )...
if (err == NRFX_ERROR_INVALID_PARAM) { err = nrfx_gpiote_channel_alloc(&ch); if (err != NRFX_SUCCESS) { return -ENOMEM; } } trigger_config.p_in_channel = &ch; } /* 配置trigger */ err = nrfx_gpiote_input_configure(abs_pin, NULL, &trigger_config, NULL); if (err != NRFX_...
return NRF_ERROR_INVALID_PARAM; } // Check for NULL buffer if (p_buffer == NULL) { return NRF_ERROR_INVALID_PARAM; } // Stop RTC to prevent any running timers from expiring (in case of reinitialization) rtc1_stop(); m_evt_schedule_func = evt_schedule_func; // Initialize operation...
{returnNRF_ERROR_INVALID_STATE; } m_nrf_sdh_continue=true;//Notify observers about SoftDevice enable request.if(sdh_request_observer_notify(NRF_SDH_EVT_ENABLE_REQUEST) ==NRF_ERROR_BUSY) {//Enable process was stopped.returnNRF_SUCCESS;
return NRF_ERROR_INVALID_PARAM;} if (p_ble_dfu_c->conn_handle == BLE_CONN_HANDLE_INVALID){...
Handling NRF_ERROR_INVALID_STATE error codedevzone.nordicsemi.com/f/nordic-q-a/14099/handling-nrf_error_invalid_state-error-code?ReplySortBy=CreatedDate&ReplySortOrder=Ascending 解决问题: 修改代码为: /**@brief Function for handling errors from the Connection Parameters module.** @param[in]...
* @retval ::NRF_ERROR_INVALID_PARAM Invalid parameter(s) supplied, check parameter limits and constraints. * @retval ::NRF_ERROR_INVALID_STATE [此时无法设置参数] * @retval ::NRF_ERROR_BUSY [BLE堆栈繁忙或前一个过程未完成] */ SVCALL(SD_BLE_OPT_SET, uint32_t, sd_ble_opt_set(uint32_...
p_ble_hrs_c->error_handler = p_ble_hrs_c_init->error_handler;p_ble_hrs_c->p_gatt_qu...
#define SEC_PARAM_MAX_KEY_SIZE 16 2、设置配对事件处理函数,配对绑定中需要设置的安全参数的配置,代码如下所示: static void pm_evt_handler(pm_evt_t const * p_evt) { ret_code_t err_code; switch (p_evt->evt_id) { case PM_EVT_BONDED_PEER_CONNECTED: ...