I have two Cisco 2960-l and 2 SFPs GLC-BX-U I inserted SFPs and there switches can see SFP but status is notconnect here is some Information from both switches show interface gigabitEthernet 0/10 GigabitEthernet0/10 is down, line protocol is down (notconnect) Hardware is Gigabit Eth...
errdisable ス テー トのインタ ーフ ェイス を表示 し ます. OL- 29499-01-J Catalyst 2960, 2960-S, および 2960-P スイッチコマンドリファレンス 2-691 spanning-tree extend system-id 第 2 章 Catalyst 2960, 2960-S, 2960-C, および 2960-P スイッ チの Cisco IOS コマ...
SFP error messages: hulc_sfp_iic_intf_read_eeprom sfp _index 1 yeti_iic_read_retry fail POST: ACT2 Authentication : End, Status Failed. Redundant Power System (RPS) error message: %PLATFORM_ENV-1-RPS_ACCESS: RPS is not responding. ...
Box 2: Disable loading the query to the data model For every query that loads into the model memory will be consumed. and Memory is our asset in the Model, less memory consumption leads to better performance in most of cases. The best approach is to disable loading. The above free exam ...
lost carrier error/ no neighbor Brromeo Level 1 10-16-2019 08:28 AM Recently replaced a 3845 in my Data Center with a ISR 4331. Used the same Fiber SFP that was in the 3845 in the 4331. My network monitor is showing my WAN interface and completely down. This is the ...
Hi there I am using HWIC-1GE-SFP on 2811 ISR. the Gig port seems up but cannot ping the other end and does not send any traffic. any help is appreciated.
Following is the error explanation and recommended action as per cisco output interperter:- %FIB-3-FIBDISABLE (x1): Fatal error, slot [dec]: [chars] Explanation: An internal software error has occurred because of an IPC problembetween the LC and the RP. CEF swit...