Device(config)# logging host ipv6 AAAA:BBBB:CCCC:DDDD::FFFF transport tcp port 1470 Additional References for IPv6 Embedded Management Components Related Documents Related Topic Document Title IPv6 addressing and connectivity IPv6 Configuration Guide Cisco IOS commands Cisco IOS Mast...
for IPv6 17 Configuring In-band OAM for IPv6 18 Configuring In-band OAM for IPv6 Tracing (Single Path Verification) 18 Configuring Encap Node 18 Configuring Intermediate Node 20 IPv6 Network Management Configuration Guide, Cisco IOS Release 15M&T iii Contents CHAPTER 4 CHAPTER 5 Configuring ...
Run the nis-server ipv6-address command to configure the NIS server IPv6 address for the DHCPv6 address pool. Run the nis-domain-name nis-domain-name command to configure the NIS domain name suffix allocated by the DHCPv6 server to the client. Run the nisp-server ipv6-address command to ...
Configuration Examples for VXLANs Further ReadingConfiguring VXLAN on an IPv6 NetworkOnly the S6730-S, S6730S-S, S5732-H, S5731-S, S5731S-S, S5731S-H, S6730-H, S6730S-H, and S5731-H support IPv6 network-based VXLAN configuration.Configuring...
In the Test Type list box, select Ping (for an IPv4 configuration) or Ping6 (for an IPv6 network configuration). If the test was successful, the message Ping of ip_address succeeded message appears below the Destination field in the Network Configuration Test screen....
The Network Configuration Test screen appears.From the Test Type list box, select Ping (for an IPv4 configuration) or Ping6 (for an IPv6 network configuration).Type the IPv4 or IPv6 test destination address in the Destination field and click Test. If the test was successful, the message ...
The defaultnetwork ACLrule is marked with an asterisk (*) and is the very last rule that will be used for matching. Status:EnabledorDisabled. Enabled rules are applied, while disabled rules are not. Type:IPv4orIPv6. Action:AlloworDeny. If a request matches anetwork ACLrule, the action ...
2. After PE 2 receives the packet, it searches for a route that matches the destination IPv4 address of the packet in the routing table of the public network. The corresponding End.DT4, End.DT46, or End.DX4 SID is found. Then, PE 2 encapsulates an outer IPv6 header for the packet....
The In-band OAM for IPv6 profiles and service profiles are linked with the ACL on a one-to-one basis. There is a one-to-one match between In-band OAM for IPv6 profile and its related service profile which is necessary for the In-band OAM for IPv6 configuration to work. All ...
IPv6 network-based VXLAN configuration is supported only by the device equipped with the X series cards as the tunnel-side interface.Configuring VXLAN in Centralized Gateway Mode Using Static Mode Tradução Coleção Baixar Documentos Última atualização:2025-01-20 № do documento:EDOC...