Example:To close the console of the TCPIP virtual machine and send this output to a specific user ID, use this NETSTAT command: netstat cp spool cons close touserid Up to32766bytes of the CP command response are displayed by the NETSTAT command. ...
The above example is similar to what we've already looked at, but instead of displaying all connections, we're telling the command to show only the connections that are using a specific PID,28604in this example. A similar command could be used to filter out the connections with aCLOSE_WAIT...
When the-@flag is used with thenetstat -rcommand and noWparNameparameter is specified, all of the routes in the system’s route table are displayed. If theWparNameparameter is specified and the WPAR-specific routing is enabled for that WPAR, only the routes associated with that WPAR are di...
In Example G.11,“Displaying IP socket status with netstat” we will look atnetstat's numeric output and thenwe'll invoke the same command but suppress the host lookups. Though the outputis almost the same, a particular situation might call for one or the otherinvocation. Example G.11. Di...
To use netstat, open a command prompt or terminal window and type "netstat" followed by the options you want to use. For example, you can follow these steps to give netstat a try: Step 1: Open the start menu, type cmd into the search box, and press Enter to launch the command promp...
Example G.15. Displayingthe masquerading table with netstat [root@masq-gw]# netstat -Mn FIXME;this command seems to fail on all of the iptables boxen, even if I'm usingthe -j MASQUERADE target. I can use it successfully on ipchainsboxen. Anybody have any ideas or explanation here?
This example shows the output of the basicnetstatcommand. Note that IPv4-only information is displayed. $netstatTCP: IPv4 Local Address Remote Address Swind Send-Q Rwind Recv-Q State --- --- --- --- --- --- --- lhost-1.login abc.def.local.Sun.COM.980 49640 0 49640 0 ESTABLISH...
For example, the netstat command option -m has the parameter buffer pool. The pool for which information will be displayed can be specified, as in the command netstat -m sys. Do not enter the underlined option or parameter; enter a value for the information represented by the underlined ...
All we need to do is to run netstat –na –p UDP command. Below is an example of the displayed output: -e parameter This parameter displays Ethernet statistics. This is self-explanatory through the output example you can see below: -s parameter This parameter displays statistics by protocol...
Figure 1. Example output for command "netstat -an" The information that is displayed includes the protocol, the local address, the remote (foreign) address, and the connection state. Note that the various IP addresses include port information as well. An explanation of the different connection ...