(model: R3CON). Unused channels can be specified and set so on the PC Configurator Software without needing to short at the field terminals. + 18 T/C comp. wire – INPUT 6 – 19 CJC SENSOR 20 + 21 T/C comp. wire – INPUT 7 – 22 CJC SENSOR 23 +...
** Data range must be setup with the PC Con!gurator Software R3CON and the dedicated cable. 73VR1100 SPECIFICATIONS ES-7399 Rev.24 Page 13/18 https://www.m-system.co.jp/ MODEL: 73VR1100 • R5 Series Remote I/O • ETHERNET Tower Light SIGNAL TYPE DC voltage input ...
Remote I/O R3 Series CAUTION ■ UNUSED INPUT CHANNELS Set the unused channels to -20 – +20 mA or 0 – 20 mA range. Otherwise, set them as “Unused” with PC Configurator software: R3CON. Unused channels left open with 4 – 20 mA setting are equal to the input lower than...
Unused channels can be specified and set so on the PC Configurator Software (model: R3CON) without needing to connect resistors at the field terminals. R3Y-RS8 SPECIFICATIONS ES-8959 Rev.9 Page 4/5 https://www.m-system.co.jp/ MODEL: R3Y-RS8 INPUT CONNECTOR (40-pin) PIN NO...
software: R3CON.Unused channels left open may be equal to the input lower than -15%, which sets a data abnormality at the PLC or the host device. 130 [5.12] RELATED PRODUCTS • Connector terminal block (model: CNT) 110 [4.33]
MODEL: R3Y-SS8 Remote I/O R3 Series CAUTION ■ UNUSED INPUT CHANNELS Set the unused channels to -20 – +20 mA or 0 – 20 mA range. Otherwise, set them as “Unused” with PC Configurator software: R3CON. Unused channels left open with 4 – 20 mA setting are equal to th...
PC Configurator Software (model: R3CON). R3Y-DS8N SPECIFICATIONS ES-8968 Rev.8 Page 3/4 https://www.m-system.co.jp/ MODEL: R3Y-DS8N INPUT CONNECTOR (40-pin) PIN NO. 1A ASSIGNMENT GND GND +24V +24V -IN8 PIN NO. 1B ASSIGNMENT GND GND +24V +24V...
Unused channels can be specified and set so on the PC Configurator Software (model: R3CON) without needing to connect resistors at the field terminals. R3-RS8A SPECIFICATIONS ES-8407 Rev.9 Page 4/5 https://www.m-system.co.jp/ MODEL: R3-RS8A Specifications are subject to change...
software: R3CON.Unused channels left open may be equal to the input lower than -15%, which sets a data abnormality at the PLC or the host device. DC CURRENT INPUT MODULE (8 points, non-isolated, tension clamp terminal block) 27.5 (1.08) ...
Internal power: Via the Installation Base (model: R3-BSx) Isolation: Input to internal bus or internal power Conversion rate: Selectable with the side DIP SW RUN indicator: Bi-color (red/green) LED; Red when the bus A operates normally; ...