HANGER A N D SUPPORT SPACING SP-69 Thread size Inch (m) 1I4 Torque Inch Pound (Nm) 40 60 125 250 400 665 4.5 6.8 14.1 28.2 45.2 75.1 9.1 The recommended maximum spacing of hangers and supports shall be as shown in Table 3. 3/8 1/2 518 314 718 6.4 9.6 12.7 15.8 19.0 Spacings...
SP-69 FOREWORD ThisStandardPracticewasdevelopedbyacooperativeeffortofrepresentativesof thepipehangermanufacturers.Itisbasedonthebestpracticecurrentatthistime andonthecollectiveexperienceoftheindustry.Therearethreecompanion standards-MSS SP-58andMSSSP-89relatetohangermaterials,design, ...
i 标准分享网 免费下载 MSS STANDARD PRACTICE SP-58 FOREWORD This Standard Practice was developed by a cooperative effort of representatives of the pipe hanger manufacturers. It is based on the best practice current at this time and on the collective experience of the industry. There is a ...
i 标准分享网 免费下载 MSS STANDARD PRACTICE SP-58 FOREWORD This Standard Practice was developed by a cooperative effort of representatives of the pipe hanger manufacturers. It is based on the best practice current at this time and on the collective experience of the industry. There is a ...
c o m MSS STANDARD PRACTICE SP-58 9 5.3.7 Fiberglass Reinforced Pipe (FRP) a) The size of hanger shall be suitable for the O.D. of the pipe to be supported. b) Support spacing shall be based on the pipe manufacturers recommendations for the service condition. c) FRP should not be ...
SP-69 FOREWORD ThisStandardPracticewasdevelopedbyacooperativeeffortofrepresentativesof thepipehangermanufacturers.Itisbasedonthebestpracticecurrentatthistime andonthecollectiveexperienceoftheindustry.Therearethreecompanion standards-MSS SP-58andMSSSP-89relatetohangermaterials,design, ...
where design load ratings for rigid pipe hanger such information is not otherwise providedassemblies see Table 1 2.7 To serve as a companion document to MSS 1.4 This Standard Practice presents the SP-127 which provides recommendations for the recommended practice for the selection and design, selecti...
Hanger Rods (Metric) 6 3 Recommended Minimum Rod Diameter for Single Rigid Rod Hangers 8 4 Maximum Horizontal Pipe Hanger and Support Spacing 10 5 Spring Support Selection 12 6 Clamp Tolerances 19 7 Preheat and Post-Weld Treatment Requirements 25,27 7M Preheat and Post-Weld Treatment ...
2 Load Ratings of Carbon Steel Threaded Hanger Rods 5 2M Load Ratings of Carbon Steel Threaded Hanger Rods Metric. 63 Recommended Minimum Rod Diameter for Single Rigid Rod Hangers 84 imum Horizontal Pipe Hanger and Support Spacing 105 Spring Support Selection. 126 Clamp Tolerances 19 7 Pre...