We have a MSA 2000 with two controllers PN AJ803A but at last week, one of the controllers went offline and now we need to replace it. We have a new controller and as we can see, this new controller with PN AP837A is supported by MSA 2000 and our question is: ca we work with...
format? You should never replace a Compact card from another controller or try swapping it with each other (Make a note for future reference) . Every CompactFlash card has a signatureto a controller. There may be a reason why you do notsee a CompactFlash Card as customer replaceable...
5. Shut down the SAN, replace controller B, and remove controller A > Power on the SAN >The repeat the firmware update on controller B. 6. When done restart controller B. NoteYou can manually downgrade the firmware on controller B if youDONTwant to disable Partner Firmware upgrades. CLINo...
IMPORTANT:In environments with a P2000 G3 FC/iSCSI MSA controller, install either the Fibre Channel or the iSCSI VDS Provider; do not install both providers on the same host. VDS Providers for the different protocols are not supported concurrently for the same controller. After installing the VD...
We have a MSA 2000 with two controllers PN AJ803A but at last week, one of the controllers went offline and now we need to replace it. We have a new controller and as we can see, this new controller with PN AP837A is supported by MSA 2000 and our question is: ca we work with...
I think so controller is factory default, U just replace this one & see what is status.BR/Yaqub 0 Kudos Reply JimTaylor Advisor 07-15-2008 03:37 AM Re: MSA2000 - problems with Management NIC.. Spoke to HP and they're happy that it is probably a fault with the ...
- Check the SAS expansion cable between enclosures connected through the indicated port, and replace the cable if necessary.\n- If this does not correct the problem, check that the modules at each end of the cable are powered up and have good health; replace any faulty controller module or...
- Check the SAS expansion cable between enclosures connected through the indicated port, and replace the cable if necessary.\n- If this does not correct the problem, check that the modules at each end of the cable are powered up and have good health; replace any faulty controller module or...
- Check the SAS expansion cable between enclosures connected through the indicated port, and replace the cable if necessary.\n- If this does not correct the problem, check that the modules at each end of the cable are powered up and have good health; replace any faulty controller module or...
Should I replace the SAS Controllers with ISCSI of Fiber? What I need to know is the maximum load in IO that one controller can have, so that I can calculate how many VMs to use. Is it possible to find it somehow? 0 Kudos Reply Torsten. Acclaimed Contributor 10-30-...