lgetxattr("foobar", "system.posix_acl_access", 0x0, 0) = -1 ENODATA (No data available) In addition atcpdumphas been captured during while running thels -lusing the command: Raw # tcpdump -s0 -i INTERFACE host NFS.SERVER.IP -w /tmp/tcpdump-acl.pcap Notice the GETACL Call's o...
Before you perform troubleshooting, make sure that the mount target is in theAvailablestate. If the mount target is in theHibernatedstate, you must re-enable the mount target by using the console or API. For more information, seeHibernate a mount target. ...
If it is 0, then the setting of mntentfsnoautomove will be used. See mntentfsnoautomove below. This option can be changed after the file is mounted by changing this bit and setting the request bit, mntentnewauto, to 1 before calling __mount(). If changed to 0, also set mntentfsno...
>8No change needed Note Thenconnectoption is available only for Linux kernel 5.3+ VMs. You might need to restart the VM when you're upgrading the kernel. That means it might not be applicable for some cases. Use NFSv3 instead of NFSv4.1 when you're considering only...
The following options are available: -m Mount the file system without making an entry in /etc/mnttab. -g Globally mount the file system. On a clustered system, this globally mounts the file system on all nodes of the cluster. On a non-clustered system this has no effect. -o ...
($logInfo + "The NFS client is installed and an NFS mount target is available.") Write-Output ($logInfo + "The NFS client is installed and an NFS mount target is available.") | Out-File -FilePath $logPathFile -Encoding default -Append $nfs_url = "mount -o nolock -o mtype=ha...
This would start off from 5 states, even though the whole application may have many more states available. It would then exclude two states (i.e. #'foo/c and #'bar/d), then it will pass runtime arguments {:a 42}, and finally it will start the remaining three states: #'foo/a, ...
mount invokes the mount callable service to mount a file system, making the files in it available for use. The caller must have mount authorities to mount a file system. See the section on mounting file systems in z/OS UNIX System Services Planning. When used in a sysplex, mount can al...
If a file system is mounted by using the –hard option and becomes unavailable, an application that uses this file system hangs until the file system becomes available. Using the mount Command The following examples show different scenario: In NFS Version 2 or NFS Version 3, both of the ...
我还注意到以下两种情况:前提条件:我在fstab中有以下条目: /dev/sda3 /test_mount ext4 rw,acl,nobarrier,nodelalloc 0 0 (因此,test_mount.mount文件是在重新启动后在/var/run/systemd/generator/目录下生成的。) 场景1:我从fstab中删除了条目,并重新启动了机器。我的期望是test_mount.mount文件应该从/var...