alias ipv6 off 此步可以禁止ipv6,但重启网络会提示报错FATAL: Module off not found. 解决方法如下: 1. alias ipv6 off 替换成 options ipv6 disable=1 2. /etc/sysconfig/network 新增如下一行 NETWORKING_IPV6=off
一、添加ipv6地址(tomcat所在服务器) 1、动态添加ipv6 (1)添加IPV6地址 ip -6 addr add <ipv6address>/<prefixlength> dev <interface> ip -6 addr add 2400:A480:AAAA:200::147/64 dev eth0 (2)添加默认路由 ip -6 route add <ipv6network>/<prefixlength> via <ipv6address> ip -6 route add...
modprobe: FATAL: Module nf_conntrack_proto_sctp not found in directory /lib/modules/5.4.0-125-generic kubernetes要开启ipvs 模式,首先ipvs的几个内核模块要加载起来!其中就包括ip_vs、ip_vs_rr、ip_vs_wrr、ip_vs_sh、nf_conntrack_ipv4、nf_conntrack_ipv6、nf_conntrack_proto_sctp。 然而由于linux系统...
We found that withipv6.disable=1added to the kernel boot line ingrub.confsctp.ko would not load. Changingipv6.disable=1toipv6.disable=0, sctp module get loaded properly and sctp connections are also established. Is theipv6module required by thesctpmodule even if the system has no IPv6 ...
The multicast ipv6 invalid-packet command sets the maximum number of invalid IPv6 multicast protocol packets that can be stored on the switch. The undo multicast ipv6 invalid-packet command deletes the set maximum number of invalid IPv6 multicast protocol packets that can be stored on the switc...
InvalidParameterValue.UserNotSupportIPv6IPv6 is not supported. LimitExceeded.ModuleSecurityGroupLimitExceededThe number of default module security groups exceeds the limit. LimitExceeded.SecurityGroupModuleLimitExceededThe number of modules that can be associated with the security group exceeds the limit. ...
The IPv6 function has been enabled on the interface using the ipv6 enable command in the interface view. Precautions The priority of the ipv6 icmp port-unreachable send disable command is higher than that of the ipv6 icmp port-unreachable send disable command. If both the commands are ...
ip6table_nat nf_conntrack_ipv6 nf_defrag_ipv6 nf_nat_ipv6 ip6table_mangle ip6table_security ip6table_raw iptable_nat nf_conntrack_ipv4 nf_defrag_ipv4 nf_nat_ipv4 nf_nat iptable_mangle iptable_security iptable_raw nf_conntrack ip_set ebtable_filter ebtables ip6table_filter devlink ip6...
IPv6 DHCP configuration was disabled for I/O module [arg1] by user ID [arg2] from [arg3] at IP address [arg4]. The specified user has requested that IPv6 DHCP configuration to be disabled for the specified I/O module. Severity Informational Alert Category User activity (Informational) Lo...
IPv6 static configuration was disabled for I/O module [arg1] by user ID [arg2] from [arg3] at IP address [arg4]. The specified user has requested that IPv6 static configuration to be disabled for the specified I/O module. Severity Informational Alert Category User activity (Informational)...