The information in this manual is subject to change without notice and does not represent a commitment on the part of Model Technology. The program described in this manual is furnished under a license agreement and may not be used or copied except in accordance with the terms of the ...
From Library tab, right click on 'work' and select refresh. (See the attached image.) Now, start simulation. While searching for this, I spent couple of hours. But didn't get succeed until got work-around or solution from my colleague. Anyway, I hope ...
Some searching shows that this is likely to be a 32/64-bit problem. I also have experience of trying to get ModelSim PE, which is 32-bit, running on an RH7 64-bit system for an evaluation. It's difficult, and I gave up, even after a lot of input from th...
messages: # /usr/bin/ld: skipping incompatible /usr/lib/gcc/x86_64-linux-gnu/4.9/libgcc.a when searching for -lgcc # /usr/bin/ld: cannot find -lgcc # /usr/bin/ld: skipping incompatible /usr/lib/gcc/x86_64-linux-gnu/4.9/libgcc_s.so when searching for -lgcc_s # /usr/bin/ld: ...
With PADS you can easily design and place bare-die components on chip-on-board (COB) and multi-chip modules (MCM), ball grid arrays (BGAs), and chip-scale packages (CSPs). A variety of die, die flag, and route wizards make it easy to route single-chip packages and define die flags...
From Library tab, right click on 'work' and select refresh. (See the attached image.) Now, start simulation. While searching for this, I spent couple of hours. But didn't get succeed until got work-around or solution from my colleague. Anyway, I hope this would be useful to s...
From Library tab, right click on 'work' and select refresh. (See the attached image.) Now, start simulation. While searching for this, I spent couple of hours. But didn't get succeed until got work-around or solution from my colleague. Anyway, I hope t...
From Library tab, right click on 'work' and select refresh. (See the attached image.) Now, start simulation. While searching for this, I spent couple of hours. But didn't get succeed until got work-around or solution from my colleague. Anyway, I hope th...
Some searching shows that this is likely to be a 32/64-bit problem. I also have experience of trying to get ModelSim PE, which is 32-bit, running on an RH7 64-bit system for an evaluation. It's difficult, and I gave up, even after a lot of input from the FAE...
From Library tab, right click on 'work' and select refresh. (See the attached image.) Now, start simulation. While searching for this, I spent couple of hours. But didn't get succeed until got work-around or solution from my colleague....