镜像源端口:(配置成功无报错) dis mirroring-group 1 Mirroring group 1: Type: Local Status: Incomplete Mirroring port: Bridge-Aggregation6 Both Bridge-Aggregation7 Both Bridge-Aggregation14 Both Route-Aggregation2 Both Route-Aggregation4 Both Route-Aggregation90 Both 配置监控端口报错: mirro...
Mirroring group 2: Type: Local Status: Active Mirroring port: FortyGigE1/0/5 Inbound Monitor port: FortyGigE1/0/6 Encapsulation: Destination IP address 1.1.1.1 Source IP address 2.2.2.2 DSCP 1 VLAN 2 VRF Instance 3 Destination MAC address 0011-0200-0211 Table 1 Command output Field Descripti...
The tunnel interface acts as the monitor port in the local mirroring group created on the source device. 2. The tunnel interface on the source device forwards the mirrored packet to the tunnel interface on the destination device through the GRE tunnel. 3. The destination device receives the mir...
想把interface GigabitEthernet1/2/0/4 退出mirroring-group 1 local，用命令【GigabitEthernet1/2/0/4...
Run the undo port-mirroring { inbound | outbound } vlan { vlan-id1 [ to vlan-id2 ] } command to delete the configuration of the Layer 2 mirrored port. Run the undo port-mirroring { inbound | outbound } fragment command to disable packet mirroring on MP-Group interfaces. Only MP-Grou...
Configure a local observing port or an observing port group. Configure a local observing port. Run observe-port [ observe-port-index ] interface { interface-type interface-number | interface-name } A local observing port is configured. By default, no local observing port is configured. Configu...
Hi @Eric Hutchinson_2 Let say you have created port mirroing using follow command [Device] mirroring-group 1 local[Device] mirroring-group 1 mirroring-port gigabitethernet 1/0/1[Device] mirroring-group 1 monitor-port gigabitethernet 1/0/3 To remove port mirror on interface you can follow...
A note for Tesla users: Do not use this app while driving. The use of this app may be restricted based on your local jurisdiction. This app should only be used when the car is parked. A vehicle with the MCU2 hardware is required for screen mirroring. ...
For a project access token or group access token, use the username (not token name) and the token as the password. SSH authentication SSH authentication is mutual: You must prove to the server that you’re allowed to access the repository. The server must also prove to you that it’s wh...
A note for Tesla users: Do not use this app while driving. The use of this app may be restricted based on your local jurisdiction. This app should only be used when the car is parked. A vehicle with the MCU2 hardware is required for screen mirroring. ...