1.17. The onset of acceleration creep is correlated with the onset of microstructure evolution causing coarsening of laths and blocks in martensitic microstructure. Therefore, the tm, which reflects the microstructure stability during creep, is a deciding factor for the creep life. Show moreView ...
A fifth power dependence of minimumcreep-rate on applied tensile stress was observed when the ratio of strain rate to diffusivity was less than 10 9 cm −2; however, above this ratio a stronger dependence was found. The creep-rate data are in agreement with contemporary correlations between...
Dielectric Elastomer Minimum Energy Structures (DEMES) have the ability of actively adjusting their shape to accommodate complex scenarios, understanding the actuation mechanism of DEMES is essential for their effective design and control, which has rend
Right — I remember when the city of SeaTac, Washington (named after the airport, which is in the center of it) was lauded on high for raising their minimum wage to 15 dollars an hour, so all those hotel and restaurant workers (remember, airport is the center of the economy there) co...
The elected design pipe shall first self-penetrate through its own weight to a specific distance below the seafloor dependent upon subsurface soil conditions until a first point of resistance (FPR) is observed. From this point, slack of weight (SOW) will be zeroed and jetting will commence. Si...
Further, it is shown that dislocations lower the energy of deforming systems and thus are energetically favorable defects during deformation. The quantitative treatment of viscous (linear velocity-stress law) dislocation motion of non-interacting dislocations, similar to behavior expected and observed in ...
Under the condition of a given value, the relative influence of changing the characteristic value of transverse reinforcement on the prediction can also be observed from the ALE plot. In addition to the influencing trend, the ALE plot is an effective approach for identifying the boundary value of...
Under the condition of a given value, the relative influence of changing the characteristic value of transverse reinforcement on the prediction can also be observed from the ALE plot. In addition to the influencing trend, the ALE plot is an effective approach for identifying the boundary value of...