2. Secure the hard drive to the front panel using a screwdriver. 3. Push the hard drive into the subrack along the guide rails until it cannot move forwards. 4. Close the ejector lever and push the hard drive in position. Figure...
ofthecushionwithaPhillips-headscrewdriver.Caution:Do notremoveclamps. 2.Rotatetheswivelclamplocatedattherearundersideofseat cushion. 3.Whileliftingtherearedgeofthecushion,pullthecushiontothe rearandremove. Installation 1.Placetheforwardedgeofthecushiontwoinchestotherearofthe ...
2. Using a small Phillips screwdriver, remove the 4 hard drive mounting screws. Component replacement procedures 41 3. Slide the tab (1) to disconnect the hard drive from the computer, and then lift the hard drive (2) out of the bay. Reverse this procedure to reassemble and install the ...
2. Slide the battery release latches (1) to release the battery. 3. Remove the battery (2). Reverse this procedure to install a battery. 36 Chapter 4 Removal and replacement procedures SIM NOTE: This section applies only to computer models with WWAN capability. NOTE: If there is a SIM ...
2. Slide the battery release latches (1) to release the battery. 3. Remove the battery (2). Reverse this procedure to install a battery. 44 Chapter 4 Removal and replacement procedures SIM NOTE: This section applies only to device models with WWAN capability. NOTE: If there is a SIM ...
2. Slide the battery release latches (1) to release the battery. 3. Remove the battery (2). Reverse this procedure to install a battery. 36 Chapter 4 Removal and replacement procedures SIM NOTE: This section applies only to device models with WWAN capability. NOTE: If there is a SIM ...