表 1 美军 MIL-STD-461G 标准试验项目序号 类别 编号 试验项目1传导发射CE101电源线传导发射(30 Hz ~ 10 kHz)2 CE102电源线传导发射(10 kHz ~ 10 MHz)3 CE106 天线端口传导发射4传导敏感度CS101电源线传导敏感度(30 Hz ~ 150 kHz)5 CS103 天线端口互调传导敏感度6 CS104天线端口无用信号抑制传导...
图2:MIL STD 461G CE102 传导发射 MCF-028010-001 与 HAE100-24S28W(Vin(标称值)和满载条件下的组合) MIL 应用中的另一个挑战是宽范围的输入电压,包括严重的瞬态和尖峰。下表显示了不同标准的摘要: 根据MIL-STD-1275,28V 额定电压在引擎启动期间可能会降至 16V,甚至在系统初始接合期间会降至 12V 一秒钟。
MIL-STD-461G;发射;敏感度;适用性;步骤 Abstract The differences between the MIL-STD-461G and MIL-STD-461F are introduced in detail. The characteristics and trends of the changes are summarized. Some of the reasons for the change are analyzed. Keywords MIL-STD-461G;emission;susceptibility;appli...
表 1 美军 MIL-STD-461G 标准试验项目序号 类别 编号 试验项目1传导发射CE101电源线传导发射(30 Hz ~ 10 kHz)2 CE102电源线传导发射(10 kHz ~ 10 MHz)3 CE106 天线端口传导发射4传导敏感度CS101电源线传导敏感度(30 Hz ~ 150 kHz)5 CS103 天线端口互调传导敏感度6 CS104天线端口无用信号抑制传导...
MIL-STD-461G RS103 What is MIL-STD-461G CE102? MIL-STD-461G CE102 ensures that EM emissions from the equipment being tested do not exceed the power lead and AC / DC limits outlined in Figure CE102-1 of MIL-STD-461. MIL-STD-461G CE102 is applicable to equipment installed on: Su...
Figure 2. MIL-STD 461G CE102 Conducted Emission MCF 028010 001 combined with HAE100 24S28W at Vin (nom) and full load. Image used courtesy of Bodo’s Power Systems [PDF] Another challenge in MIL applications is the wide range of input voltages, including heavy transients and spikes. The...
MIL-STD-461G provides a lot of detail in the general and interface requirements section on establishing and managing the test configuration. Configuration management is critical in the standardization process where each test laboratory should obtain the same results within the margin of uncertainty. We...
MIL-STD-810G试验项目表(GJB150A-2009) MIL-STD-461F试验项目表(GJB151B-2013) 第2部分:低气压试验500.4Low Pressure 5.4 CE101 25Hz~10kHz电源线传导发射 第3部分:高温试验501.4High Temperature 5.5 CE102 10kHz~10MHz电源线传导发射 第4部分:低温试验502.4Low Temperature 5.6 CE106 10kHz~40GHz天线端口...
CE101 Conducted Emissions 30 Hz to 10 kHz AC Power Leads from Ship Power CE102 Conducted Emissions 10 kHz to 10 MHz AC Power Leads CS106 Conducted Susceptibility Transients Modified AC Power Leads from Ship Power (Tested as par...
偶尔,电源转换器的直流输出要求满足MIL-STD-461CE03或CE102的标准,此时就需要附加的滤波设备,包括差模和共模方式的滤波器。为满足这种要求,在某些器件中VPT的滤波器需要放置在转换器的输出处。 (二)传导敏感度 电子线路不仅产生噪声而且对于其他地方产生的噪声会有敏感反应。传导敏感度要求规定为在电源线路中传导不会...