/interface vlan add name=($name . "-vlan" . $i) interface=$name vlan-id=($i) /interface bridge port add bridge=("bridge" . $i) interface=($name . "-vlan" . $i) } } } 这里根据ethernet接口,生成全部的VLAN。并把vlan加入到相应的bridge中。 所以这个脚本,应该在运行之前,运行添加桥的...
add bridge=bridge102 interface=vlan102 add bridge=bridge103 interface=ether3 add bridge=bridge103 interface=vlan103 add bridge=bridge104 interface=ether4 add bridge=bridge104 interface=vlan104 该配置为我项目中实际使用的配置。 端口5为trunk,端口1,2,3,4分别是access口。 当然我没有更复杂的应用。 三...
在交换机里设置相应的VLAN,在连接路由器的端口设为TRUNK以及VLAN
所以我找到了答案。在设法获得Mikrotik交换机之后。有一个用于连接到MK命令提示符的很好的类-它在这里...
3.2.1. Trunk 接口设置 设置sfp-sfpplus1、bond_5-8 为Trunk接口。 /interface bridge port set bridge=bridge interface=sfp-sfpplus1 frame-types=admit-only-vlan-tagged ingress-filtering=yes set bridge=bridge interface=bond_5-8 frame-types=admit-only-vlan-tagged ingress-filtering=yes ...
Configure vlan on Cisco Catalyst 2960 switch On the 2960 switch, the port connecting to the Mikrotik RB750 router and those connecting to the Mikrotik access points (caps) will be configured as a trunk ports while the rest will be access ports. Vlans 10 and 20 will be allowed through the...
this means that you can achieve wire-speed performance using VLANs if a proper configuration method is used. The configuration method changes across different models, this guide will focus on setting up a basic trunk/access port with a management port from the trunk port using different devices ...
vlan-header (add-if-missing | always-strip | leave-as-is; Default: leave-as-is) Sets action which is performed on the port for egress traffic. add-if-missing - adds a VLAN tag on egress traffic and uses default-vlan-id from the ingress port. Should be used for trunk ports. always...
SwOS interface menu consists of multiple tabs depending on the device model. These are all possible SwOS menus: Link, PoE, SFP, Port Isolation, LAG, Forwarding, RSTP, Stats, Errors, Hist, VLAN, VLANs, Hosts, IGMP, SNMP, ACL, System, Health and Upgrade. ...
* add-if-missing - adds a VLAN tag on egress traffic and uses default-vlan-id from the ingress port. Should be used for trunk ports. * always-strip - removes a VLAN tag on egress traffic. Should be used for access ports. * leave-as-is - does not add nor removes a VLAN tag on ...