This study describes how to manage internet clients of an ISP with PPPoE and MikroTik, using freeRadius for centralized AAA (Authentication, Authorization and Accounting). It is based on the work done at AlbaniaOnline ISP (now called Primo). The aim was to give PPPoE service to the internet ...
/ip pppoe-server enable ether1 This configures PPPoE server on ether1 interface. ether1 interface should be up. No ip address configuration is required on interface. Next thing is to add users with group PPP. We will add user test with password seCreT in this example: /user add name test...
3 chain=input action=accept src-address=10.8.0.0/24 in-interface=Byfly-PPPoE log=no log-prefix="" 4 chain=input action=accept src-address=10.6.0.0/24 in-interface=Byfly-PPPoE log=no log-prefix="" 5 ;;; Allow IKE chain=input action=accept protocol=udp dst-port=500 log=no log-prefix...
To request a trial license, you must run the command "/system license renew" from the CHR device command line. You will be asked for the username and password of yourmikrotik.comaccount. Warning:If you plan to use multiple virtual systems of the same kind, it may be possible that the ...
通过命令行界面设置软路由的网卡地址、网关等基本参数。常用操作命令：ROS 默认Username : admin Password: [空]①返回上一层目录 .. ②补全命令 TAB ③重启/关机 /system reboot /system showdown ④备份路由 /system BACKUP 回车 save name=文件名 ⑤恢复路由 /systemBACKUP 回车 load name=文件名 ...
Set the name and select ether1 as the interface; Go to the Dial Out tab, configure the username, password, and other parameters; Click OK to save the settings.Further in configuration, the WAN interface is now the pppoe-out1 interface, not ether1. ...
For [[PPPoE]] it is the MAC address (written in CAPITAL letters) a client must connect from. For ISDN it is the caller's number (that may or may not be provided by the operator) the client may dial-in from }} {{Mr-arg-table |arg=comment |type=string |default= |desc=Short ...
/radius/add service=login address=172.17.0.2 secret="client_password" ,where the address is the IP address of the veth3 interface, secret is the secret that we configured in the clients.conf file and service is the allowed service that you wish to use. ...
When winbox.exe is downloaded, double click on it and winbox loader window will pop up: [[File:Wb-man-1.PNG | center]] To connect to the router enter IP or MAC address of the router, specify username and password (if any) and click on '''Connect''' button. You can also enter ...
The items #1 and #3 show, that OSPF protocol is running on the interface ether1, and two routes have been installed by the routing daemon. The routes are marked as invalid, because these routes match the connected routes, but there should not be two routes to the same destination. This ...