Microsoft kernel debug network adapter是干什么的??? 只看楼主 收藏 回复 KuX裤衩 小有美名 5 今天在设备管理器里查看隐藏设备看到了这个东西,请问这是干什么的额。能不能禁用或卸载呢??? 爱 婧猫 赫赫有名 13 楼主你看这段英文简写就是DNA啊,可想而知了吧 KuX裤衩 小有美名 5 自顶一下...
2.Microsoft Kernel Debug Network Adapter is a virtual NIC designed for kernel-mode debugging which facilitates remote debugging of the Windows operating system over a network connection. It provides a communication channel between the computer’s kernel and the debugger software, enabling develo...
5 展开"网络适配器"树形目录结构，如图所示。鼠标右击"Microsoft Kernel Debug Network Adapter"项，弹出快捷菜单选择"属性"项。6 弹出"属性"对话框。选择"常规"标签，点击"启用设备"按钮。7 这样无法开启WIFI热点故障问题就解决了。
Depending on the specifics of the VM in use, you may need to change the network settings for your virtual machines to bridge them to the Microsoft Kernel Network Debug Adapter. Otherwise, the virtual machines will not have access to the network. ...
This virtual NIC is named the “Microsoft Kernel Debug Network Adapter”. It is pre-installed on all Windows 8 machines, but it is only enabled once kernel debugging over networking is enabled. When it’s enabled, it carries your normal traffic (TCPIP, etc.) out to the physical NIC that...
Depending on the specifics of the VM in use, you may need to change the network settings for your virtual machines to bridge them to the Microsoft Kernel Network Debug Adapter. Otherwise, the virtual machines will not have access to the network. ...
To do kernel debugging over a network cable, the target computer must have a supported network adapter. When the target computer is running Windows, the network adapters listed here are supported for kernel debugging.Version InformationThis topic lists the supported adapters for...
You can do kernel debugging over an Ethernet network cable when the target computer is running Windows 8. The target computer must have a supported network interface card (NIC) or network adapter. During kernel debugging, the computer that runs the debugger is called thehost computer, and the ...
Get-VM -VMName test-vm | Get-VMNetworkAdapter | fl * 将MAC 地址更改为唯一的静态地址,或切换到使用动态 MAC 地址。 在知识库 2742844 中进行了描述 展开表 问题克隆失败,作为源 DC 的副本启动进入 DSRM 现象 新克隆在没有进行克隆的情况下启动。 未重命名 dccloneconfig.xml,而且服务器以 DS 还原模...
Configure kernel–mode debugging by using the EthernetTo enable kernel-mode debugging on the target system:On the host system, open a Command Prompt window and enter ipconfig to determine its IPv4 address. Output Copy Windows IP Configuration Ethernet adapter Ethernet: Connection-specific DNS ...