Microphones don't work: I tried 2 microphones on my new PC, but they do not pick up any sound at all. I tried setting them to 100. They definitely work mechanically, since I tested them on my laptop. They are registered in the system's Device Manager as a microphone. I have no id...
Access the BIOS setup screen on the device. When the device is not powered on, press and hold the [F2] key on the keyboard, then press the power button to turn on the device. Keep holding the [F2] key until the BIOS setup screen appears, then release the [F2] key. Learn more abo...
Microphones are too low: I have bought a new computer, using Windows Home 11.My microphones are working ok on my laptop and my partner's laptop and computer.I have tried 3 different microphones, one does not work on my new PC, the other 2 work but the volume is too low.I have trie...
When the device is not powered on,press and hold the [F2] key on the keyboard, then press thepower buttonto turn on the device. Keep holding the [F2] key until the BIOS setup screen appears, then release the [F2] key. Learn more aboutHow to enter the BIOS setup screen. ...
UEFI Diagnostics: When I was going to run the microphone record test, there was a message that the internal microphone is not currently supported and to run the HP PC Hardware Diagnostics Windows to further diagnose. (BTW I did hear a number of tones- so the speaker was working). When...
Not commercially successful Inspired inventors to developed more advanced mics A liquid microphone is based on Ohm’s law — current in a wire varies inversely with the circuit resistance. The mic contains a battery, needle, wire, and a metal cup with a diaphragm placed over the top. The met...
If no, my understanding from that test is that there can be 3 sources of errors. Either the THAT is not working, or my acquisition card is not working, or the problems is somewhere on the board between those two components (i.e bad welding). Last time i used the acquisition card (...
My friend Jim told me a funny story the other days.On a dark and stormy night,a fellow is walking through a place where died people were buried.As he walked further along,and he heard a voice saying,"Mark!Mark!"Pretending not to let it bother her,he pulled his coat a little tighter...
My friend Jim told me a funny story the other days.On a dark and stormy night,a fellow is walking through a place where died people were buried.As he walked further along,and he heard a voice saying,"Mark!Mark!"Pretending not to let it bother her,he pulled his coat a little tighter...
Adding on, the 5-volt output was connected to the breakout board in the video. I don't see how I can do that myself without also implementing a breakout board. Photo #6 This shows the audio cable being plugged into the XH 3-pin connector. What I do not understand is where the 3rd...