The microstructural observations by scanning electron microscopy and energy dispersive spectroscopy analyses revealed that the distribution of Mo particles within the brass matrix of brass-30 wt% Mo composites was not as fine as the other samples. According to the results, the relative density and ...
(2) Corrosion characteristics of brass exposed to the biodiesel-diesel fuel blends were determined by means of a static immersion method at room temperature. (3) Mechanical properties of brass were investigated before and after the corrosion test. Finally, (4) variations in surface morphologies of...
In this study, Cu-Zn-Al-Fe β-brass alloys were prepared through homogenization annealing and hot-rolling annealing. The effects of Zn and Al contents on the microstructure and mechanical properties of β-brass alloys were assessed. The results show that Cu-Zn-Al-Fe β-brass alloys comprise ...
The texture consists of a major copper component and a minor brass component. The latter strengthens with alloying. Due to shear deformation in the surface region also a rotated cube component is found. It is stronger in the pure material and is partly added up in the bulk during ARB. Due...
Mechanical properties of the joints were assessed on the grounds of static tensile test, technological bending test, as well as hardness measurements. Quality of the obtained joints was good. No cracks were observed in the brazed joints and the obtained mechanical properties were satisfactory....
The other mechanical properties of wood are very much what we should expect from a bundle of tubes or fibres. Recrystallized microstructure and mechanical properties of cold worked brass annealed by electropulsing and routine annealing were studied. In addition, effects of TPUE on the mechanical prop...
BrassRecrystallizationMechanical propertiesPlastic cold deformationPurpose: The aim of the investigations is to determine the influence of the recrystallization temperature on the microstructure and mechanical properties of the brass CuZn30 subjected to cold deformation in the process of rolling at various ...
Microstructure, mechanical properties and tribological behaviour of PM Fe-Cu-Zn alloys containing solid lubricantsExperimental/ bendingbrassgraphitehardnessiron alloyslubricantslubricationporositypowder metallurgypressingFe-Cu-Zn alloys containing solid lubricants of graphite and talc produced via cold pressing and...
The present paper involves the measurement of standard values of tensile test by using JIS No. 4 test bar the study on substantial tensile properties of various sections of the step formed and L formed castings concerning high strength yellow brass. The obtained standard tensile properties are as...
Leaded yellow brass UNS C85700 has a copper content of not less than 58%.Tabulated below are the mechanical properties of UNS C85700 centrifugal cast alloy as a function of heat treatment.TemperTensile Str.Yield Str.Elong. M02 276MPa (40ksi) 97MPa (14ksi) 15%...