RTS Toggle specifies that the RTS line will be high if bytes are available for transmission. After all buffered bytes have been sent, the RTS line will be low. You can use this to switch direction if you have a 232/485 converter without an automatic direction switch. The use of RTS cont...
BIOS SETUP 4.4.2 I/O Device Configuration Onboard FDC Swap A & B [No Swap] This field allows you to reverse the hardware drive letter assignments of your floppy disk drives. Configuration options: [No Swap] [Swap AB] Floppy Disk Access Control [R/W] Set this field to read and write...
Thank you for choosing NIO EL6 model (hereinafter referred to as "EL6"). EL6 is a smart electric vehicle. We will provide you with considerate and thoughtful user services during your green journey with EL6. Before embarking on a journey with EL6, it is recommended that you read the "...
Spain 34 91 640 0085, Sweden 46 (0) 8 587 895 00, Switzerland 41 56 2005151, Taiwan 886 02 2377 2222, Thailand 662 278 6777, Turkey 90 212 279 3031, United Kingdom 44 (0) 1635 523545 For further support information, refer to the Technical Support and Professional Services appendix. ...
At the same time, the outer door handles are retracted, and the side mirrors are automatically folded (enter the Settings interface on the Center Display, and tap Position Adjustment > Side Mirror > Auto Fold on Lock to set the automatic folding of side mirrors). After locking, the lift...
This can be especially important if the available network bandwidth is limited, or if video is to be stored (recorded) at a high frame rate and there are storage space restraints. The lower bandwidth demands come at the cost of higher complexity in encoding and decoding, which in turn ...
The supply voltage can be up to 24V. With its high energy efficiency from Trinamic's CoolStep™ technology cost for power consumption is kept down. The TMCL firmware allows for standalone operation and direct mode control. Main characteristics • Motion controller & stepper motor driver: – ...
to Traqmate to setup user information Unit Information – connects to Traqmate to change user information Firmware Update – connects to Traqmate to update SU or DU firmware Driver Setup – opens the setup window to select graphs and laps Session Tools – access to Swap Axis, Time Zone, ...
The ATF_USETRAILERS flag is used to record the receipt of such a reply, and enables the transmission of trailer packets to that host. ARP watches passively for hosts impersonating the local host (that is, a host which responds to an ARP mapping request for the local host's address). arp...
STP configuration, including STP status (enabled or disabled), link attribute (point-to-point 33 XGPON OLT Operation Manual V1.1 or not), STP priority, maximum transmission speed, loop prevention status. QoS configuration, including traffic limiting, priority marking, default 802.1p ...