Attaching the legs Removing the trim Studio Integration Audio Connections Line Level Input/Outputs Connecting a Patchbay Mic Inputs Instrument Inputs DAW Connection Overview Installing the ipMIDI Driver and Logictivity Browser Software Installation (Macintosh) 3-1 3-1 3-1 3-1 3-1 3-1 3-1 3-...
Attaching the hand strap Attach the hand strap to the instrument to help prevent its being dropped. 3. Loading the battery Place the battery correctly in the battery box at the back of main body. For loading the battery, refer to "2.1 Battery loading and replacement". ―――C―ha―pte―...
69 1.4.14 Attaching and detaching objects ... 70 1.4.15 Keyboard shortcuts ... 71 2 Building stations 75 2.1 Workflow of building a station ...
04.01 Attaching the arm leash Disconnect the arm cuff from the leash. WING CONNECTION ARM CUFF CONNECTION 04.02 Inflating the wing Spread the wing out on a surface without any hard or sharp objects. Place the wing with the leading edge in the wind. Weigh down the wing next to the strut ...
Attaching the tilt foot When recording with the built-in mic, you can attach the included tilt foot to the tripod mounting threads to prevent the mic from being too low when placing the unit with the bottom side (battery compartment cover side) down. When not using the tilt foot, you ...
63 1.3.13 Attaching and detaching objects. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 64 1.3.14 Keyboard shortcuts . . . . . . . . . . . . . . . . . . . . . . . . . ...
∫ Attaching the Lens Hood (Supplied Accessory) 1 Align the fitting mark E on the lens hood with the mark on the tip of the lens. 2 Turn the lens hood in the direction of the arrow until it stops, and align the stop mark F on the lens hood with the mark on the tip of the ...
Read chapter Network Security in the MDM 500 end user manuals before attaching the computers to your local area network. Tip If the access to the MDM 500 database is lost after changing the network address, it is most likely because the Open Database Connectivity (ODBC) connection has ...
Connect the 300 ohm twin-conductor wire from the loop antenna to the pair of screw termi- nals labeled AM LOOP, attaching one wire to each terminal. It does not matter which wire attaches to which terminal, but make sure that the connections are solid and that the two wires do not ...
When a group change is requested, your radio initiates an attachment to the SwMI, detaching the old group and attaching to the new one. All group attachments sent by your radio are sent with attachment mode of Amendment or Detach all... depending on which form causes sending fewer bits ...