The fluid resistance coefficient is the ratio of total pressure loss to velocity pressure at the cross section of reference. (8.93)C=ΔPtoρV2/2=ΔPtoPv Where ΔPto is the total pressure loss and Pv is velocity pressure. For all fittings, except joints, the total pressure loss is ...
Chromosome per cell counts in RPETP53−/−cells of control, WGD, 6-weeks post-WGD (6w-pWGD) and 20-weeks post-WGD (20w-pWGD) populations. The number of cells considered for each condition is indicated.c, Tumour volumes (mm3 × 100) from the time of subcutaneous injection in N...
2015). The test–retest reliability of the MVC measures based on coefficient of variation (CV) was 3.9 %. Range of motion (ROM) of the elbow joint To examine the elbow joint ROM, two elbow joint angles (extended and flexed joint angles) were measured using a goniometer (Takase Medical,...
Step 3: Bend your elbow slowly and lower your hips towards the ground in a controlled manner till your elbow makes a 90-degree angle. Step 4: Hold this position for 2-3 seconds and then move upward to come back to your normal position. Repeat the same for 10-15 times. Inclined push-...
Test–retest reliability was assessed by the coefficient variation (CV) and the intraclass correlation coefficient (ICC), using 6 healthy men (23.8 ± 4.9 years, 169.4 ± 5.0 cm, 75.7 ± 15.4 kg), with 2 days between the two measures, without any intervention. The CV and ICC of the meas...
the fluid (kg/m3), v is the average velocity of the fluid (ms−1), 𝑙ℎlh is the length of the horizontal channel (m), 𝑑ℎdh is the diameter of the horizontal channel (m), 𝜆λ is the pressure coefficient along the path and 𝜉ξ is the local resistance coefficient. ...
the fluid (kg/m3), v is the average velocity of the fluid (ms−1), 𝑙ℎlh is the length of the horizontal channel (m), 𝑑ℎdh is the diameter of the horizontal channel (m), 𝜆λ is the pressure coefficient along the path and 𝜉ξ is the local resistance coefficient. ...
The higher the kinetic energy recovery coefficient is, the greater the recovery degree of outlet cross-section water kinetic energy is. The kinetic energy recovery coefficient of outlet conduit 𝜂𝜔ηω is as below: 𝜂𝜔=𝑣̲2in/2𝑔−𝑣̲2out/2𝑔−Δℎin-out𝑣̲2in...
We used the IQTree webserver [38] to run a Maximum Likelihood (ML) analysis using 10,000 ultrafast Bootstrap approximation (UFBoot) replicates with 10,000 maximum iterations and minimum correlation coefficient of 0.99 [39], plus 10,000 replicates of Shimodaira–Hasegawa approximate likelihood ...