Check the network settings on the user's computer. Make sure that the computer is set to automatically obtain an IP address and DNS server address. You may also want to try flushing the DNS cache. Try restarting the NAS and the user's computer. This can sometimes res...
2023-11-16 01:06:02 add_route_ipv6(::/3 -> :: metric -1) dev utun4 2023-11-16 01:06:02 /sbin/route add -inet6 :: -prefixlen 3 -iface utun4 route: writing to routing socket: Network is unreachable add net ::: gateway utun4: Network is unreachable 2023-11-16 01:06:02...
When I comment out the 'push "redirect-gateway def1"' line Iamable to connect to the internet but the local network remains locked away for some reason... I do know that the app states my private ip is in the 10.8.0.* range. ...
Configure an IP address. Run: ip address ip-address { mask | mask-length } An IP address is configured for the dialer interface. Configure the interface to obtain an IP address from the remote device. Run: ip address ppp-negotiate...
The local tunnel interface fails to ping the IP address of the remote tunnel interface. Procedure When the network layer protocol of one or both ends of a tunnel is Down Check that interfaces on both ends of the tunnel use the same tunnel encapsulation mode. Run the display this interface...
thenright-click[properties],inthe[network][clicktabin theInternetprotocolversion4(TCP/IPV4)], ChoosetousethefollowingIPaddress[],inthe"IPaddress" fillin"192.168.0.1"inthe"subnetmask"fillin "255.255.255.0",otherdonotfill,andthenclick"OK"tosolve ...
Again : your local modem does not contain a firewall and doesn't have routing capabilities. Describe your network. You can mention all RFC1918 IP's, as we all use the same. Mention your WAN IP's - just mask the last byte. No "help me" PM's please. Use the forum, the community...
I think that you have configured the OpenVPN server the opposite way to my configuration. In my configuration the ‘Local Network’ is always one of the subnets on the OpenVPN server side. The ‘IP Pool’ can be just any private IP range as long as it does not conflict with the subnet...
To test unhappy flow scenarios for this app, we'd like to power cycle the device we are connecting to by using an IoT power switch that connects to the local network using WiFi (a Shelly Plug-S).In my test code on iOS13, I was able to do a local HTTP call to the IP address ...
IPv6 local unicast address, but not with their Link-Local address. However, router R2 is directly connected to R1 and R3 hence it can communicate with both the routers with their Link-Local address, because Link-Local addresses are used only within that local network specific to the physical...