Port Number: 1 Port Priority: 32768 Oper-Key: 1 # 显示动态聚合组内成员端口Ten-GigabitEthernet1/0/2上链路聚合的详细信息。 <Sysname> display link-aggregation member-port ten-gigabitethernet 1/0/2 Flags: A -- LACP_Activity, B -- LACP_Timeout, C -- Aggregation, D -- Synchronization, E...
port link-aggregation group group-id [ force ]// 将二层以太网接口加入聚合组 多次执行此步骤可将多个二层以太网接口加入聚合组 指定force参数时,表示接口加入聚合组时同步该聚合组的属性类配置和mac-vlan enable命令配置 link-aggregation port-priority priority// (可选)配置端口优先级 缺省情况下,端口优先级...
interface bridge-aggregation interface route-aggregation jumboframe enable lacp default-selected-port disable lacp edge-port lacp mode lacp period short lacp system-priority link-aggregation forwarding-acceleration enable link-aggregation global forwarding-acceleration enable ...
If LACP preemption is enabled and Port 3 needs to replace Port 1 or Port 2 to become the active interface, set the highest LACP priority value for Port 3. When LACP preemption is not enabled, the system does not re-select the active interface even if the priority of a backup interfac...
The highest priority backup link becomes the active link and begins forwarding data. Load Balancing Using Link Aggregation A data flow is a group of data packets with one or more identical attributes. The attributes refer to the source MAC address, destination MAC address, source IP address, des...
桥优先级 (Bridge Priority):是一个用户可以设定的参数,数值范围从0到61440 。设定的值越小, 优先级越高。交换机的桥优先级越高,才越有可能成为根桥。 根端口 (Root Port):非根桥的交换机上离根桥最近的端口,负责与根桥进行通信,这个端口到根 桥的路径开销最低。当多个端口具有相同的到根桥的路径开销时,...
switch (config) # show interfaces port-channel summary Flags: D - Down, U - Up, P - Up in port-channel (members) S - Suspend in port-channel (members), I - Individual --- Group Port- Type Member Ports Channel --- 1 Po2(U) LACP Eth1/58(D) Eth1/59(I...
Since the weight for a bundle member is greater than or equal to 1 and less than or equal to 10, the total member of links in a bundle is less than 64 in mixed bundle case. • Any type of Ethernet interfaces can be bundled, with or without the use...
To configure Link Aggregation Control Protocol (LACP) priority for a port , enter the bundle port-priority command in interface configuration mode. To return to the default LACP priority value, use the no form of this command. bundle port-priority ...
4actor port_priority:65535actor key:4actor state:activitytimeoutaggregationsynchronizedcollecting<br></br>distributingpartner sys_id:00:12:f2:cc:6d:40partner sys_priority:1partner port_id:12partner port_priority:1partner key:10000partner state:activityaggregationsynchronizedcollecting<br></br>...