Adjust the 02 red layer to your engrave settings, and the 01 (blue) and 00 (black) layers to your cut settings. You can choose whether to set the 02 (red) layer to simply engrave the outline of the butterfly using the Line mode or to fill it with the Fill mode....
used function that requires closed shapes isFillmode, which commands your laser to engrave or mark an area that falls within the outline of a single specified shape, or between the outlines of two shapes. Without knowing what area is inside a shape, LightBurn can't determine what to fill. ...
As with the other timing values, you are looking for a value where the lines meet at a nice right angle. - For the Laser On TC, look at the beginning of the fill-lines. - For the Laser Off TC, look at the end of them. Here is a testcard I ran on a 20W Galvo with a “...
outline decal_lines decal_text decal_vector_text bore counterbore There are three operations I want to perform: cut through 3mm MDF, engrave MDF surface with a line, and engrave MDF surface with a raster fill. In my CAD all of the lines are the same colour. That’s fine. If ...