To make this discussion easier to understand I’m going to grossly exaggerate some numbers and stick with imperial measurements. For the sake of this discussion let’s assume we’ve drawn a square that is8"x8"and we’ve asked lightburn to fill this square. You know that LB will start at...
There are three operations I want to perform: cut through 3mm MDF, engrave MDF surface with a line, and engrave MDF surface with a raster fill. In my CAD all of the lines are the same colour. That’s fine. If the drawing is too cluttered I can turn layers on and off to...
This is most obvious to the human eye when looking at line segments. If you draw a simple line segment with a node on each end, it makes no sense to say there is an inside and an outside to it. Following from that, if you assign that line segment to a layer set to Fill mode,...