Step 7: Now move the layers in the cuts/layer dialog in this order: Red (02), Blue (01), and Black (00). The reason that we have two cut layers is that we want to make sure that the hole is cut before the overall shape is cut. Lightburn is very good at working out that ...
How many times the laser will repeat the shapes on this layer. Sometimes, when cutting thick material, trying to engrave very deep, or using a lower power laser, more than one pass may be necessary. Perforation Mode✉¶ If you are trying to cut fold lines in card stock, stitch holes...
DXF export now includes proper layer info (Wazer software compatibility) Added support for letter spacing in imported SVG text Added “Trim Shapes” tool (scissors) Added “Completed” field to Repeat Marking window for galvo, to track completed part count Initial WeCreat Vision camera support over...
In terms of underlying software it means that layer names are unique, but colours are not, i.e. several layers could have the same colour, because the elements on those layers should be cut in the same way. I have already put the suggestion on your suggestions site. I might ...
In the Cylinder Correction Setup dialog, shown above, there is aShow Valid Boundarybutton at the bottom. Click on this and it will insert a rectangle, on the T0 tool layer, into your design, showing you the area in which your design can be placed. ...
An example of this is shown below by the selected rectangle in the green layer, which has it’s output disabled, but has been used to move the job origin down to where it needs to be. image1436×914 74.4 KB I believe the reason nothing has been implemented so far is that there will...