首先需要编辑PPTP配置文件,找到“require-mppe-128”这一行,在其后添加一行“lcp-echo-interval 30”。这个命令表示每隔30秒发送一次LCP Echo消息,用来检测连接是否存活。接着保存配置文件并重新加载PPTP服务即可生效。 通过配置PPTP连接使用LCP Echo,可以有效提高连接的稳定性,减少连接中断的情况。同时,定期发送LCP Echo...
MTU：最大传输单位，用户可以根据不同应用特点自行调节，但最大不可超过1500，默认值为1492。MSS：最大段长度，默认值为1432。LCP-Echo 请求的次数及请求之间的时间间隔进行配置。
if (get_wan_unit_value_int(unit, "ppp_alcp") > 0) fprintf(fp, "lcp-echo-adaptive\n");
优酷-提供视频播放,视频发布,视频搜索 - 视频服务平台,提供视频播放,视频发布,视频搜索,视频分享 - 优酷视频
Hello, My PPPoE connection restarted and I found this in the system log: No response to 5 echo-requests Serial link appears to be disconnected. However, on the WAN configuration page "LCP echo failure threshold" is set to 0 so it should ...
> > I believe that the PPP interface filters out the LCP echoes before tcpdump > sees the packets. You might look in the pppd source and see what a LCP > echo looks like in the code, then create the filter accordingly. It might > also show up in kdebug packet dumps, but I haven...
As you state, you've turned off LCP echoes > sent from your end, but that does not stop the ISP from sending them. The > 'idle' option considers the ISP's echoes as legitimate packets, so does > not bring the line down. I know, I know (sigh). > Check the pppd man page ...
LCP echo failure threshold 青云英语翻译 请在下面的文本框内输入文字,然后点击开始翻译按钮进行翻译,如果您看不到结果,请重新翻译! 翻译结果1翻译结果2翻译结果3翻译结果4翻译结果5 翻译结果1复制译文编辑译文朗读译文返回顶部 LCP回应失败临界值 翻译结果2复制译文编辑译文朗读译文返回顶部...
The PPP terminating equipment 100 thereby produces and returns the response packet to the LCP echo requirement.隅田 光一
No response to 20 echo-requests， 频繁掉线。我明白这是运营商完美，宽带的质量不好。但是目前的小区...