Link type of an interface: Hybrid Access Trunk Mode Mode in which an interface joins a VLAN: Tagged Untagged Click OK. The interfaces to be added are added to Added Interface List on the Select interface page. (Optional) Select interfaces to be deleted in Added Interface List and click to...
After the system is restarted, LAN1 and LAN2 become uplink ports. The WAN-side HTTPS access control function is disabled by default. Therefore, the web interface cannot be accessed locally through LAN1 and LAN2, and the web interface that has been connected will be interrupted. ...
The full format of -r is: PROTOCOL://LOCAL_IP:LOCAL_PORT@[CLIENT_KEY]CLIENT_LOCAL_HOST:CLIENT_LOCAL_PORT4.7.1. Protocol PROTOCOL: tcp or udp. For example: -r "udp://:10053@:53" -r "tcp://:10800@:1080" -r ":8080@:80" If the --udp parameter is specified, PROTOCOL defaults ...
This process starts the conversion of Layer 2 links to Layer 3 links, which is done by traversing the network graph built during new device onboarding. First, the lower device link is converted to a Layer 3 IP address. Next, the upper device link ...
The full format of -r is: PROTOCOL://LOCAL_IP:LOCAL_PORT@[CLIENT_KEY]CLIENT_LOCAL_HOST:CLIENT_LOCAL_PORT 4.7.1. Protocol PROTOCOL: tcp or udp. For example: -r "udp://:10053@:53" -r "tcp://:10800@:1080" -r ":8080@:80" If the --udp parameter is specified, PROTOCOL defaults...
Link aggregation (LAG) Multicast unicast mode Wired Guest Access Q. What features are not supported on 5500 Series Controllers? A.These software features are not supported on 5500 Series Controllers: Static AP-manager interface Note:For 5500 Series Controllers, you are not required to...
Please follow this FAQ to configure the Client-to-LAN L2TP VPN server on TP-Link routers:https://www.tp-link.com/en/support/faq/3025/ With Client-to-LAN (Client-to-Site) VPN, the VPN client can access the remote network resources. If you have set up the VPN server, connected the ...
For full instructions see the following: Configuring a Linksys wireless router Configuring a D-Link wireless router If you are using more than one ATA behind the same router then you may want to set the SIP port on each ATA device so that they will not conflict with each other. Using...
target. Multicast traffic, in the case of multicast IP, is not addressed to the router's MAC layer address, but simply sent to the MAC-layer equivalent of the IP multicast destination address. IP multicast packets are not addressed to the router at either the Network or Data Link layer!
On the one hand, it can scan (in two modes: quick scan and full scan) and display the detail about each computer in your current LAN (including host name, OS version, IP address, MAC address, sharing resources, etc.) in the form of a simple & readable list; and allows you to view...