百度试题 结果1 题目单选 下列哪个协商模式不属于LACP(). A. on B. passive C. Auto D. Active 相关知识点: 试题来源: 解析 C 反馈 收藏
CISCO(config-if-range)#channel-protocol lacp CISCO(config-if-range)#channel-group 1 mode active CISCO(config-if-range)#exit CISCO(config)#exit # 查看华为设备。[~HUAWEI] display eth-trunk 1Eth-Trunk1's state information is: Local: LAG ID: 1 Working Mode: Static System Priority: 32768 Sys...
(1) 請確認兩端的聚合線路運作在相同的LAG模式,例如,若本地端運作於LACP,另一台也需要設定為 LACP。 (2) LACP有兩種模式: Active 和 Passive,在 Active 模式中,連接不可以主動的傳送 LACP 封包; 而在 Passive 模式中,連接埠只能在接收到 LACP 封包後傳送 LACP 封包,建議一端設為Acive mode,另一端設為 P...
Full NamePort Aggregation ProtocolLink Aggregation Control ProtocolStatic Mode StandardCisco proprietaryIEEE 802.3adNone (Static configuration) CompatibilityCisco devicesMultivendor, IEEE standardLimited, depends on vendor support NegotiationYesYesNo ModesAuto:Passive, waits for PAGP packetDesirable:Active, sends...
Some device models support only the manual mode. A device can set up a LAG with a remote device only when LACP is enabled on both devices and the same interfaces are selected as active interfaces on both devices. If LACP is not enabled on the remote device, the local device might attempt...
51CTO博客已为您找到关于lacp multimode的相关内容,包含IT学习相关文档代码介绍、相关教程视频课程,以及lacp multimode问答内容。更多lacp multimode相关解答可以来51CTO博客参与分享和学习,帮助广大IT技术人实现成长和进步。
Dell S4810P configuration (I have tried both passive and active modes): interface TenGigabitEthernet 0/8 no ip address ! port-channel-protocol LACP port-channel 5 mode passive no shutdown ! interface TenGigabitEthernet 0/9 no ip address ! port-channel-protocol LACP port-channel 5 mode passi...
You will notice, that you can also set the mode to either active or passive. This is the mode in which the vDS decides to initiate the LACP negotiation. In Passive mode, it will remain silent and not transmit any LACP BPDU frames unless the switch on the other side initiates the session...
Now go over to the uplink port group on your VDS. You will see the new LACP option: You will notice, that you can also set the mode to either active or passive. This is the mode in which the vDS decides to initiate the LACP negotiation. In Passive mode, it will remain silent and...
Then active links will load balance data to do communication. LAG vs LACP: What’s the Difference? LAG (link aggregation group) refers to the initial technology to realize link bundling and load balancing without any protocol involved. It is also called the manual mode, because of its working...