输入TESTZ Z=-或者Z=+则移动到前两个值的中值位置从而缩小范围。 反复调整,直至纸张正好能抽动,并且有一定的摩擦力。 输入ACCEPT,然后SAVE_CONFIG保存配置,自动重启后传感器校准就完成了。 另外输入PROBE_ACCURACY的话,可以测量重复精度。 3.网床校准 网床校准通过测量热床上各个点的高度来生成热床深度图,从而通过...
The connectors for FANs and Heaters are isolated by mosfet, The connectors for temperature thermistors and Endstops/Probe in some boards like MKS are normally connected to GND by filtered capacitors, Mount the BDsensor near to the hotend, as shown in the figure below.STL of mount,STL_mount_V...
I was getting this error during a bed mesh calibration. I figured out that I needed to make the points farther apart (increase time between probes) and the error went away. This is on a HermitCrab toolchanger setup with separate mcu at toolhead. So it seems that after a probe, klipper...
输入TESTZ Z=-或者Z=+则移动到前两个值的中值位置从而缩小范围。 反复调整,直至纸张正好能抽动,并且有一定的摩擦力。 输入ACCEPT,然后SAVE_CONFIG保存配置,自动重启后传感器校准就完成了。 另外输入PROBE_ACCURACY的话,可以测量重复精度。 3.网床校准 网床校准通过测量热床上各个点的高度来生成热床深度图,从而通过...