If INPUT_SHAPING=0 or not set(default), disables input shaping for the resonance testing, because it is not valid to run the resonance testing with the input shaper enabled. OUTPUT parameter is a comma-separated list of which outputs will be written. If raw_data is requested, then the...
5.Настройка Input Shaping впрошивке MarlinKlipperKlipper на Orange Pi3 LTS - легкоибыстроЗдесьвыложеныпредварительнонастроенныеобразы Linux (Armbian и Debian) для Orange Pi3 LTS сужеус...
We read every piece of feedback, and take your input very seriously. Include my email address so I can be contacted Cancel Submit feedback Saved searches Use saved searches to filter your results more quickly Cancel Create saved search Sign in Sign up Reseting focus {...
Refer to your ST-Link manual for the pinout on the adapter (not all ST-Links have the exact same pinout)! Caution Mind the orientation of the boards in pictures below, refer to the markings on the mainboard/toolhead! Mainboard ST-Link pins location: Toolhead ST-Link pins location: Inse...
Refer to your ST-Link manual for the pinout on the adapter (not all ST-Links have the exact same pinout)! Caution Mind the orientation of the boards in pictures below, refer to the markings on the mainboard/toolhead! Mainboard ST-Link pins location: Toolhead ST-Link pins location: Inse...
It will also disable input shaping if it was enabled previously, as it is not valid to run the resonance testing with the input shaper enabled. Attention! Be sure to observe the printer for the first time, to make sure the vibrations do not become too violent (M112 command can ...
Refer to your ST-Link manual for the pinout on the adapter (not all ST-Links have the exact same pinout)! Caution Mind the orientation of the boards in pictures below, refer to the markings on the mainboard/toolhead! Mainboard ST-Link pins location: ...