sample-probe-as-z-endstop.cfg sample-pwm-tool.cfg sample-raspberry-pi.cfg docs klippy lib scripts src test .gitignore COPYING Makefile README.md Breadcrumbs klipper /config / Latest commit JamesH1978 config: Change of alias for heater_fan in multiple configs (#5632) ...
config docs klippy lib scripts src test configs klippy sdcard_loop bed_screws.cfg bed_screws.test bltouch.cfg bltouch.test commands.test delta.test delta_calibrate.cfg delta_calibrate.test dual_carriage.cfg dual_carriage.test exclude_object.cfg exclude_object.test extruders.cfg extrude...
The advantage of the dual switch and proportional feedback sensor is that they have a "neutral" zone that in theory can reduce thrashing between compression and tension. In practice with te correct tuning of sync_multiplier_low/high this is note an issue. mmu_hardware.cfg config: [mmu_sensor...
Dual mode: Use a purge tower. You'll need it. Using a draft shield can help minimise cross-contamination. I haven't tested this, but turning off z-hop may help ensure the nozzle wipes the draft shield. That said, ensure you're z-hopping on retraction. This also z-hops on tool ch...
Gently peel of the tape so they're seperated after. remove the Dual-Z-stepper-cable and store it somewhere. If the conversion is sucessful you wount need it anymore.Sovol SV06 Pinout🍪🍬 DONE. Time for a cup of hot drink and a cookie or a sweet. 🍪🍬...
CS: This dual purpose pin can be used as the chip select line in SPI mode, but also determines whether the board will boot up into I2C or SPI mode. The default of logic high sets the board up for I2C, and manually setting this pin low and resetting will cause the device to enter ...
I actually only want to move Z up relative and never more down than it went up. So I could also allow Z up without homing but always set Z0 to the last position automatically. Something in those lines. Sorry, something went wrong. ...
Expand Up@@ -49,9 +49,7 @@ def __init__(self, toolhead, config): self.printer.lookup_object('gcode').register_command( 'SET_DUAL_CARRIAGE',self.cmd_SET_DUAL_CARRIAGE, desc=self.cmd_SET_DUAL_CARRIAGE_help) defget_steppers(self,flags=""): ...
back to the printer the Y-motor-cable and dual-Z-motor-cable are taped together. Gently peel of the tape so they're seperated after. remove the Dual-Z-stepper-cable and store it somewhere. If the conversion is sucessful you wount need it anymore. ...