you can work around this by setting the following to negative value. I had set mine to almost minus one millimeter. Add the following to Z section e.g [stepper_z]. position_min: -0.99 my guess this can be done in the software ( taking the lowest value from the BED_MESH_CALIBRATION)...
Security Insights Additional navigation options New issue Move out of range#1024 Closed YaronSofferopened this issueDec 21, 2018· 13 comments Copy link YaronSoffercommentedDec 21, 2018 My guess this is happing if you have done BED_MESH_CALIBRATION ( my bed is not level at all). ...