针对“no target connected”的问题在Keil环境中出现,以下是一些可能的解决步骤和建议: 确认Keil软件与目标的连接设置是否正确: 打开Keil软件,进入项目设置(通常通过点击“Options for Target”或魔术棒图标)。 在“Debug”页签中,确认调试器是否选择为“ST-Link Debugger”。 进入“Settings”子菜单,检查端口设置(通...
一般来说，ST-LINK与STM32之间需要设置为SWD模式，并且要选择正确的芯片型号和频率。在Keil软件中，可以通过点击魔术棒图标打开Options for Target窗口，然后在Debug选项卡中选择ST-LINK Debugger，并点击Settings按钮进行设置。在Settings窗口中，可以选择Port为SW，在Flash Download选项卡中勾选Reset and Run，在Debug选...
I'm using a stm32f407vg board. Suddenly I can't download my code to flash memory. It gives me this error " Debugger - Cortex-M error: no target connected". In options
I'm using a stm32f407vg board. Suddenly I can't download my code to flash memory. It gives me this error " Debugger - Cortex-M error: no target connected". In options
编译成功之后就可以进行下载调试了,右击工程选择Options(或者Project > Options)打开工程选项配置,Debugger > Setup > Driver选择对应的硬件仿真器(以I-jet为例): 点击Download and Debug按钮或者Project > Download and Debug开始下载调试: 正常情况下应用程序会下载到目标系统,然后停在main函数入口: ...
1. 问题介绍在KEIL5软件中使用STLINK仿真器仿真时使用SW仿真时,遇到了no target connected的问题。二、解决方案通过询问买家,自己反复调试后,终于解决了这一问题,我也只是 孔妞妞2022-02-23 07:04:04 keil软件实现编程仿真需要哪些步骤 KeilMDK-ARM 是一款广泛使用的集成开发环境(IDE),专为 ARM Cortex-M 微控制...
Migration completed, Project saved as: iSO-STM32.uvprojx Note: Target memory / Debugger setup may have been changed - please check and update ! 迁移完成,项目另存为:iSO-STM32.uvprojx 注意:目标内存/调试器安装程序可能已更改-请检查并更新!
This means µVision is connected to the LPC-Link2 2. In the SW-Device box an IDCODE with SWDIO must be displayed. This means µVision is connected to the Arm CoreSight® debugger via the onboard LPC-Link2. 3. This must work correctly as shown before you can continue. You might...
If you are using the Serial 0 version of the debugging monitor, the serial cable should be connected from COM1 to the J2 / SERIAL 0 connector on the kit board. If you are using the Serial 1 version of the debugging monitor, the serial cable should be connected from COM1 to ...
with the Keil debugger, same problem I performed the following steps: 1) Connect USB cable to EZ-USB FX development board. 2) Serial comm cable is connected from COM1 of PC to SIO-1 of the EZ_USB FX board. 3) Run EzUSB application and select LoadMon to load the Ke...