Hopefully future firmware update would fix this. Anyway I am not too concerned about it, it’s not a big deal as you need 4 times the power to double your range. It’s almost the same size as the BetaFPV Lite Radio. left: BetaFPV Lite Radio 3; right: t-lite v2 From the outside...
Newest TPRO V2 Version Newest update version: T-pro with Internal 2.4G ExpressLRS Specification: Size:160*128*68 Weight: 488g (without battery) Working voltage: DC6V-DC8.4V Firmware: OpenTX Display: 1.3 inch LCD display, 128* 64 resolution Gimbal Type: HALL Sensor Upgrade method: USB onlin...
I can't see why they can't enable a dual firmware system on these radio's in the same way that most computer motherboards have a dual bios, one that is never changed and one that can be updated. It removes the bricking possibility. If the update fails, you can still boot. What ...
An SD slot is available in case you want to use a voice pack or store firmware for flashing your receivers - theSD card itself is not included- but an 8GB card should be more than enough for most use cases. I prefer the haptic feedback and generally disable the audio on all my radio...
Can’t get firmware to update hold trim buttons in and boot into dfu mode, but it won’t see the radio through serial to update. Regardless do you have some like setup documentation for setup if as if it were a fresh radio? This is my 4th radio setup and 10 years of fpv flying ...
Dear people I have a big problem with the Jumper t18. I did the upgrade to companion 2.3.10 and downloaded the firmware for the 2.3.10 and the bin file opensx-t18-lua-en.bin and installed it on my t18. The installation bar ran smoothly until the end and then ...
OpenTX Firmware Display: 1.3 inch LCD, 128*64 resolution HALL Sensor Gimbals Battery: 2×18650 Support SD card for OpenTX content Dimensions: 160x128x68mm Weight: 238g (without battery) Closer Look The Jumper T-Pro has a multi-protocol module built-in, meaning you can use this radio to...
Update: This is the Trainer port. Firmware The Jumper T16 radio comes with a very recent firmware version 2.2.3, dated back in March 17 2019. The user interface looks identical to the OpenTX firmware that runs on the Horus X10S. Apart from the logo, I really can’t tell the difference...