I have one printer and it is a Creality Ender 3 Pro. I don't know for certain, but I'm fairly confident (99.999999%) that Ultimaker did not add some sub-routine to Cura that checks to see if the active printer is a CR10S and if it is, then add a G29 into the middle of ...
ideally on opposite sides of the objects (adding more than two holes is better, though). However, sometimes you don’t want to compromise the quality of the surface, so you can position these holes so they don’t interfere with the look of the object.This is extremely important...
interface however slick it might look. And would also miss the control panel from S3D. But at this point, the S3D team can stop for me (as far as we know they already have anyway), I am done with it. Cura is without cost and WAY better maintained than S3D, and produces better ...