The hydrogen bonds formation was characterized by the shift of the bonds the peak width at half-height.R. GANEVUniversity of Chemical Technology and Metalurgy 8 Kliment Ochridski Blvd. 1156 SofiaI. GLAVCHEVJournal of Technical PhysicsGanev R., Glavchev Iv., IR Spectroscopy Characterization of...
If you are not too familiar with the low-level "packed interleaved" image storage format, the InBuf is expected to be w*h*c elements in size, where w and h is the width and the height of the image in pixels, respectively, and c is the number of color channels in the image. In ...
As a function of increasing W/S, the frequency of the main peak decreases, whereas its full width at half-height increases, values of both properties at W/S of 40.2 are close to the corresponding ones of HOD in bulk aqueous phase. These results show that the reverse aggregate-solubilized ...
Applications relying on mid-infrared radiation (λ ~ 3-30 μm) have progressed at a very rapid pace in recent years, stimulated by scientific and technological breakthroughs like mid-infrared cameras and quantum cascade lasers. On the other side, s
Reduction using CH2O microwave heating assisted (rGO-CH2O-MWT) leads to decrease of the relative intensity of the peak ascribed to hydroxyl groups with increasing intensity of peaks in C-O-C region (carbonyl moieties, e.g., in aldehyde-like structures)....
(mrDev600, Micro Resist Technology, Berlin, Germany). Finally, the remaining structure is hard-baked at 120 °C for 60 min. Thus, the produced rectangular polymer waveguide has a height of 2.6 µm, corresponding to the native layer, and a set width of 4.8 µm. Centrally from one ...
This specifies the half-width, in pixels, to use in the calculation of the numerical second derivative when creating the emission line mask. Defaults to 3 for MIR data or 20 for optical data. linemask_n_inc_thresh This specifies the number of times the flux must increase to the left/righ...
The peak value of the IR signature is in the rear aspect. It is because the temperature at the nozzle exhaust plane is much higher than that of the exhaust plume, and the maximum exposure of the projected area is in the rear aspect. The IR signature reduction in the MWIR band is ...
These spectra were obtained by first heating the succinic acid particles with a C 0 2 laser pulse (Ed- inburgh Instruments. Modei MTL-3, 80 mJIpulse, 50 ns pulse width. Phcu.sed by ZnSe lens with F.L. 500 mm). allowing 'rl-ne evaporating plume to expand for 5 ysec. and softly...
Ee max. - - 30 0.05 0.1 - 0.1 0.2 - Directivity Angle of half transmission distance ϕ1/2 - ± 45 - TYPICAL CHARACTERISTICS (Tamb = 25 °C, unless otherwise specified) Ee Optical Test Signal (IR diode TSAL6200, N = 6 pulses, f = f0, T = 10 ms) Optical Test Signal Ee UNIT...