The ip default-network command is used on routers that have IP routing enabled, and it works best alongside routing protocols. When this command is used, routes to that network are considered the gateway of last resort by the router. A static route will only affect traffic leaving the configu...
To delete all routes in the IP routing table that begin with 10., type:route delete 10.*To change the next hop address of the route with the destination of 10.41.0.0 and the subnet mask of 255.255.0.0 from 10.27.0.1 to 10.27.0.25, type:...
When a BGP routing process establishes a peering session with a peer, it goes through the following state changes: Idle—The initial state that the BGP routing process enters when the routing process is enabled or when the device is reset. In this state, the dev...
! ipv6 router ospf 1 router-id 10.2.2.2 log-adjacency-changes ! end hostname R3 ! ipv6 cef ! ipv6 unicast-routing ! ! ! interface Loopback10 no ip addressipv6 address FD01::/64 eui-64 ipv6 ospf 1 area 1! ! interface Loopback20 no ip addressipv6 address FD20::/64 eui-64 ...
Specifies that the Echo Request messages use the Loose Source Route option in the IP header with the set of intermediate destinations specified inHostList. With loose source routing, successive intermediate destinations can be separated by one or multiple routers. The maximum number of addresses or ...
In Figure 10-28, basic IS-IS functions are enabled on each routing device, and static BFD for IS-IS is configured on DeviceA and DeviceB. Figure 10-28 Network diagram of static BFD for IPv6 IS-IS When the primary link fails, static BFD rapidly detects the fault and notifies IS-IS ...
Specifies that the Echo Request messages use the Loose Source Route option in the IP header with the set of intermediate destinations specified inHostList(available on IPv4 only). With loose source routing, successive intermediate destinations can be separated by one or multiple routers. The maximum...
IPv6 Routing IPv6 Tunnels IPv6 Extensions to Solaris Name Services NFS and RPC IPv6 Support IPv6 Over ATM Support For an overview of IPv6, refer to Chapter 3, Planning an IPv6 Addressing Scheme (Overview). For tasks on configuring an IPv6-enabled network, refer to Chapter 6, Enab...
If a leaf remains unchanged, PRC does not process the routing information on any leaf. For example, if OSPF is enabled on an interface of a node, the SPT calculated by I-SPF remains unchanged. PRC updates only the routes of this interface, consuming fewer CPU resources. PRC improves the ...